Electronic Controller; Dust Extraction - Rupes HSE73 Traducción Del Manual De Instrucciones Original

POWER SUPPLY (PROVIDED OR OPTIONAL)
WARNING: For your personal safety, READ and UNDERSTAND the instruction manual of Power Supply
9HP180LT before using.
WARNING: Voltage and power frequency must match the data displayed on the identification plate of the 9HP180LT
power supply. Make sure that tool is switched off before plug is connected.
ASSEMBLE AND DISASSEMBLE POWER SUPPLY
WARNING: Before (dis)assembling the tool assure that the speed regulation Knob (2) is in OFF position.
In order to assemble the power supply, push the clip and insert the power supply in the tool till it is fixed.
In order to disassemble, push the clip and extract the power supply from the tool.
STARTING AND STOPPING
Starting: Rotate the speed regulation knob (2) and set up the speed; Now the tool can be started by pressing the START/STOP switch
lever (3). The RPM can be adjusted by rotating the speed regulator knob (2).
Stopping: Release the lever for stop the tool; Rotate the speed regulation knob until position 0 and the tool will have turned off.
WARNING: If a case of unusual vibration is present after a start of the tool, switch-off the tool immediately and
eliminate the fault.
WARNING: To reduce the risk of injury, turn the knob until OFF position (position 0) after any use.

ELECTRONIC CONTROLLER

Soft start
The soft start is electronically controlled. The soft start guarantees the motor and battery protection and reduces the risk of injury
for the operator.
Speed control
The speed of the tool can be changed by rotating the speed regulation knob (2) to the desired setting.
The speed regulation knob can be set speed for any speed between 7000 and 11000 RPM.
Tool Protections
The electronic protection protects the tool from different events that can damage the tool and create a risk of injury for the
operator. It also guarantees a longer life.
NOTICE: in a case of overcurrent or overheating caused by repeated starts or excessive overloads, the protection limits the
tool power consumption and reduce RPM. If the condition continues, the electronic protection turns off the tool.
ACCESSORIES ASSEMBLY AND DISASSEMBLY
WARNING: Before (dis)assembling the tool assure that the speed regulation knob (2) is in OFF position (0
position).
NOTICE: For have the optimal tool performance use only original accessories and consumables.
Sanding Pad
- Place the sanding pad (9) in the center;
- Tighten the sanding pad fixing screw (7). (Fig. 1)
- For disassembly: Unscrew pad's mounting screws (7).
NOTICE: Fitting non-original or incorrect sized backing pads may cause excessive vibration of the tool.
Abrasive Paper
- Used abrasive paper can be removed by simply tearing them off;
- Apply the new abrasive paper by pressing the same on the sanding pad (9), and making sure that the holes on the paper
coincide with suction holes of the pad.
NOTICE: Only Velcro abrasive paper with dust extraction holes is allowed.

DUST EXTRACTION

WARNING: Dust can be hazardous to health. Always work with a dust extractor. Always read applicable nation
regulations before extracting hazardous dust.
INTEGRATED EXTRACTION
- To guarantee optimal extraction of the powder empty the conical filter (8) in time, accurately cleaning the filter holder (8a) and
regularly cleaning the cartridge (8b);
- During works on the vertical surfaces, position the machine so the conical filter is turned downwards.
- Conical filter assembly: position the conical filter (8) on the extractor connector (4). Push the conical filter until it stops. (Fig. 2)
- Conical filter filling testing: the filling status of the conical filter is easily controlled using the transparent filter holder (8.a).
- Conical filter cleaning: to empty the conical filter, remove it from the extractor connector;
- Release the cartridge (8b) and release it from the filter holder;
- Empty the filter holder;
- Clean the cartridge plates with a soft brush.
9