LRP ANTIX S8REBEL BX3 Instrucciones página 15

POWER SUPPLY OF THE REMOTE CONTROLS
Open the battery compartment. Insert four AA batteries (alternatively rechargeable batteries) according to the polarity markings. Close the battery compart-
ment. Switch on the transmitter and check the voltage indicator LEDs.
POWER SUPPLY OF THE RECEIVER
Insert four AA batteries or a 6.0V receiver battery in hump configuration into the receiver battery box,
connect them to the switch.
As power supply in the vehicle we recommend an LRP receiver battery.
As an alternative to a NiMH receiver battery, a LiFePo battery pack can of course also be used as the
power supply in the vehicle. Attention: please only use chargers that are also suitable for charging LiFePo
batteries.
GEFAHR
WARNUNG
VORSICHT
Always switch on the transmitter first and then the vehicle.
HINWEIS
Check whether the steering servo reacts to inputs on the steering wheel and the throttle servo to inputs on the throttle grip.
ACCELERATE / BRAKE / STEER
To brake, push the lever forward.
To drive forward and accelerate, pull the lever
back.
Turn the steering wheel to the left or right,
to steer the car to the left or right.
GEFAHR
WARNUNG
VORSICHT
HINWEIS
If your vehicle makes the steering movements opposite
the way shown in the illustration, use the steering
servo reversal on your remote control.
See the next page!
LED1/2/3/4/5 : 100% Power
LED1/2/3/4: 80% Power
LED1/2/3: 60% Power
LED1/2: 40% Power
LED1: 20% Power
Gas Gas
throttle throttle
accélerer accélerer
acelerar acelerar
RIGHT
Batteriehalter in Batteriebox
Bremse Bremse
brake brake
frein frein
frenar frenar
WRONG
ENGLISH
15