Monogram ZDT925SPNSS Manual Del Propietário página 24

TROUBLESHOOTING TIPS
Save time and money! Review the charts on the following pages first and you may not need to call for service.
Problem Possible Cause
Control panel Time too long between
lights go off touching of selected pads
when setting
controls
Water standing Air gap is clogged
in the bottom of
High drain loop or air gap
the tub
not installed
Water won't Drain is clogged
pump out of the
tub
Steam This is normal
Cycle Sanitized The door was opened and
light does not the cycle was interrupted
illuminate at during final rinse
end of cycle
The incoming water
temperature was too low
Noise Normal operating
sounds: Detergent cup
opening; Water entering
dishwasher; The motor
stops and starts at
various times during the
cycle; Spray arms start
and stop at various times;
Drain pump sounds; Drain
pump starts and stops
several times during each
drain;
Rattling dishes when the
spray arm rotates
Rattling silverware
against door during wash
A white film This problem is likely
on glassware, caused by a low
dishware and quality phosphate-free
the interior Dishwasher detergent
Feel air on This is normal.
your legs when
standing in
front of the
dishwasher
during cycle
24
Each pad must be touched within 30 seconds of the others. To relight,
touch any pad again or open the door and unlock (top control).
Clean the air gap. See the Care and Cleaning section.
Refer to the Installation Instructions for proper drain line installation.
If you have an air gap, clean it. See the Care and cleaning section.
If the dishwasher drains into a disposer, run disposer clear.
Check to see if your kitchen sink is draining well. If not, you may need a
plumber.
Warm, moist air comes through the vent during drying and when water is
being pumped out. This is necessary for drying.
Do not interrupt the cycle by opening the door during the wash cycle.
Raise the water heater temperature to between 120°F and 150°F.
These are all normal. No action is required.
Max Dry Fan
Make sure dishes are properly loaded. See the Loading the Dishwasher
section.
Tall utensils may be placed in the upper rack to avoid bumping against
inner door during wash cycle.
To remove the white film, run your dishes through a dishwasher cycle with
citric acid. Use a WD35X151 citric acid kit found online. Otherwise, use high
quality rinse agents such as Cascade
Finish
Pour the citric acid in the detergent cup and close the cover. Place the
filmed but otherwise clean glassware and dishware in the dishwasher. Leave
silverware and other metal items out of the dishwasher. Turn the dishwasher
on and let it run through a complete cycle without detergent. The glassware,
dishware, and dishwasher should come out film free. Alternatively, a vinegar
rinse may be used. Pour 1 cup of vinegar into dishwasher just after the
detergent cup opens and let the dishwasher complete its cycle.
This may be repeated several times a year as needed.
The use of high quality rinse agents such as Cascade
Dry™ Rinse Aid or
repeat build up of film. Also, the use of high quality detergents such as
Cascade
Dishwashing Detergent
Do not interrupt the cycle. No action is required.
What To Do
Dishwasher Cleaner found at your local grocery store.
®
Finish Jet-Dry
®
Platinum™ ActionPacs™ or
®
will help prevent film build-up.
Platinum™ Dishwasher Cleaner or
®
Platinum™ Power
®
Rinse Aid may help minimize a
®
Finish Quantum Automatic
® ®
49-4000215 Rev. 3