Troubleshooting - Monogram ZDT925SPNSS Manual Del Propietário

TROUBLESHOOTING TIPS
Save time and money! Review the charts on the following pages first and you may not need to call for service.
Problem Possible Cause
Start status The door was opened or
indicator the cycle was interrupted.
light flashing
Dishwasher This is a reminder that
BEEPS once your dishwasher door
every minute has been left open during
operation. It will continue
beeping until you press
START and
Display Possible leak is detected
shows
"LEAK
DETECTED"
Beeping at This is normal. The
the end of dishwasher will beep twice
the cycle at the end of the cycle.
(on some
models)
Dishes and Ultra Fine or Fine filter is
flatware not clogged
clean
Low inlet water
temperature
Water pressure is
temporarily low
Air gap or disposer is
clogged
Improper rack loading
Poor performing detergent
Leak detected
Spots and Extremely hard water
filming on
glasses and
flatware
Low inlet water
temperature
Overloading or improper
loading of the dishwasher
Old or damp powder
detergent
Rinse agent dispenser
empty
Too little or low
performing detergent
22
Press the START pad once and close the door within 4 seconds to start the
dishwasher.
Press the START pad a second time when the dishwasher is running only if
you wish to cancel the cycle.
Press START and close the door.
close the door.
Some models are equipped with leak detection and the cycle will be cancelled
if a leak is detected. The display will show "LEAK DETECTED". Contact us for
service.
To turn off the double beep indicator (or re-activate it if it was previously
turned off), press the DRY OPTIONS pad 5 times within 3 seconds. A triple
beep will sound to indicate the end-of-cycle beep option has been turned on or
off.
See the Care and Cleaning section.
Make sure inlet water temperature is correct (see the Using the Dishwasher
section). Turn on the hot water faucet nearest the dishwasher, let run until
the water temperature stops rising. Then start the dishwasher and turn off the
faucet. This ensures the entering water is hot. Select Boost Temp.
Turn on a faucet. Is water coming out more slowly than usual? If so, wait until
pressure is normal before using your dishwasher. Normal water pressure to
the dishwasher should be 20-120 psi.
Clean the air gap or flush the disposer.
Make sure large dishware does not block the detergent dispenser or the wash
arms. See the Loading the Dishwasher section.
Use high quality detergents such as
Finish
®
Some models are equipped with leak detection and the cycle will be cancelled
if a leak is detected. The display will show "LEAK DETECTED". Contact us for
service.
Use high quality rinse agents such as Cascade
Rinse Aid or
film build-up.
If water is extremely hard, a softener may be required.
Make sure water temperature is at least 120°F (49°C).
Load dishwasher as shown in the Loading Place Settings section.
Make sure detergent is fresh.
Platinum™ ActionPacs™ or
Detergent.
Refill with high quality rinse agents such as Cascade
Dry™ Rinse Aid or
Make sure you use the proper amount of highly rated detergent.
What To Do
Quantum Automatic Dishwashing
®
Finish Jet-Dry Rinse Aid
® ®
Use high quality detergents such as
Finish
Finish Jet-Dry
®
Cascade Platinum™ ActionPacs™ or
®
Detergent.
Platinum™ Power Dry™
®
to prevent spots and prevent new
Quantum Automatic Dishwashing
® ®
Platinum™ Power
®
Rinse Aid.
®
Cascade
®
49-4000215 Rev. 3