Important - cecotec BOLERO DRESSCODE 2000 AUTODOSIS Manual De Instrucciones

- It is necessary to remove the transport bolts before use.
To remove them, follow these steps:
1. Unscrew all transport bolts about 30 mm with the spanner in the direction of the arrow.
Fig. 2
2. Push the 4 transport bolts horizontally inwards and loosen them. Fig. 3
3. Take the transport bolts out together with the rubber part and the plastic part. Fig. 4
4. For safety and to reduce noise, you must install the plastic taps in the holes after removing
the bolts.
5. To transport the washing machine, you must remove the taps and place the bolts again.
To do so, stand and place the transport bolt in the hole. Keep pushing in the indicated
direction until it clicks. Fig. 5

Important

Keep the transport bolts and the spanner for future transports.
Warning:
- Otherwise, the machine may suffer irreparable damage.
- Cecotec cannot be held responsible for any damage caused by failure to remove the bolts
during the use of your washing machine, nor for any damage caused if you choose to
transport it without placing the bolts correctly.
Step 2. Location
- The washing machine can only be installed in closed spaces.
- The washing machine must be installed on a solid surface.
- Do not install the machine on carpets or floorings. This may cause sliding of the device
during spinning.
- Do not store flammable liquids near the device.
- Do not install the washing machine where it can receive direct sunlight.
- For appliances with ventilation openings in the base, do not block the openings with a
carpet.
- Do not install the washing machine on humid areas.
- If you want to install your washing machine inside a compartment or cupboard, this is the
minimal distance for a stable operation:
Sides
Upper part
Rear part
Front part
25 mm
25 mm
50 mm
550 mm
BOLERO DRESSCODE 2000 AUTODOSIS / BOLERO DRESSCODE 2000 AUTODOSIS SILVER
ENGLISH
61