Parts And Components; Before Use; Installation - cecotec BOLERO COOLMARKET SBS 592 INOX Manual De Instrucciones

ENGLISH

1. PARTS AND COMPONENTS

Fig. 1
1. Freezer compartment
2. Door
3. Freezer compartment drawers
4. Refrigerator compartment
5. Door
6. Refrigerator compartment drawers
Warning
The graphics in this manual are schematic representations and may not exactly match the
product.
To make the most out of the refrigerator in terms of energy, place all the shelves and drawers
in their original position, that is, as shown in figure 1.

2. BEFORE USE

- This product includes a packaging designed to protect it during transport. Take the product
out of the box and remove all packaging materials. You can keep the original box and other
elements in a safe place, this will help you prevent product damage when transporting it in
the future. In case the original packaging is disposed of, make sure all packaging materials
are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or not in good condition, immediately contact the Technical Support Service
of Cecotec.

3. INSTALLATION

The location you choose for the refrigerator must be properly ventilated and away from heat
sources. Take into account the space dimensions shown in figure 2. Do not place the refrigerator
near heat sources, like a cooker, and avoid direct sunlight to ensure the cooling effect and save
on energy consumption. It is not recommended to place the refrigerator in a wet place, as it
may rust and cause electrical leakage.
Fig. 2
54
Height Width Depth
(doors
closed)
A (mm) B (mm) C (mm)
1793 910 698
During operation, the refrigerator releases heat into the environment. Therefore, you should
leave at least 30 cm of free space on top, more than 10 cm on both sides and at the rear of the
refrigerator. Fig. 3
Note
Figure 2 only illustrates the space required for the refrigerator.
Stable surface
Place the refrigerator on a solid, flat surface to keep it stable, otherwise vibrations and noises
will occur.
Ensure a ventilation free of obstacles around the refrigerator.
Feet levelling. Fig. 4
- Before setting the feet, make sure the refrigerator is not connected to a power socket.
- To raise the refrigerator, turn its feet clockwise.
- To lower the refrigerator, turn its feet counterclockwise.
Door levelling. Fig. 5
- Before levelling the door, make sure the refrigerator is not connected to a power socket.
Fig. 5 key:
1. Unlevelled doors
2. Fixed shaft
3. Levelling feet
4. Lock nut
5. Spanner (not included)
6. Adjustment nut
When the door is low:
Open the door, use the spanner to loosen the lock nut and turn the adjustment nut
counterclockwise to raise the door height. Once the doors are aligned, tighten the lock nut by
turning it counterclockwise.
ENGLISH
Depth Width Depth Width
(doors (doors (doors (open
opened opened opened doors
90º) 90º) 125º) 125º)
D (mm) E (mm) F (mm) G (mm)
1140 975 1010 1470
COOLMARKET SBS 592 INOX
55