Femi TS 36-523 Manual De Uso página 109

PROBLEM /
FAULT
1. The motor is 1. Faulty motor, power cable
not working or plug.
properly. 2. Blown fuses in the electrical
cabinet.
3. No voltage in the mains
system.
5. The thermal 1. The motor has overheated.
protector has 2. Motor overload caused by
tripped excessive cutting pressure.
3. Motor fault.
4. Machine 1. Tilt adjuster knob not
vibrations blocked.
2. Blade installed incorrectly.
3. Wood turns 1. Dull blade.
black during 2. Blade installed in the wrong
cutting direction.
3. The blade 1. Overload caused by trying
stops during to force the workpiece
use through too quickly or dull
blade.
TROUBLESHOOTING
EN
PROBABLE CAUSE
109
SUGGESTED REMEDY
1. Have the machine checked by
expert personnel.
2. DANGER - WARNING
NEVER ATTEMPT TO REPAIR
THE MOTOR YOURSELF: IT
COULD BE DANGEROUS.
3. Check the fuses and replace them
if necessary.
4. Check the mains power system is
present.
1. Check that motor ventilation
air uptakes are not clogged or
obstructed.
2. Perform cutting by applying the right
pressure on the workpiece.
3. Have the motor checked by expert
personnel.
1. Block the knob.
2. Secure the blade in place correctly.
1. Replace the blade.
2. Install the blade correctly observing
the direction of rotation indicated by
the arrow printed on the blade.
1. Turn the machine off and wait for
the motor to cool down.
2. Replace the blade