Schumacher Electric CR1 Manual Del Usuario página 6

Aborted Charge
If charging can not be completed normally, charging will abort. When charging aborts,
the charger's output is shut off, and the ChARgINg
an aborted charge, unplug the charger from the AC outlet, wait a few moments and plug
it back in.
Desulfation Mode
Desulfation could take up to 8 hours. If desulfation fails, charging will abort and the
ChARgINg
Maintain Mode (float-mode monitoring)
When the ChARgED
mode, the charger keeps the battery fully charged by delivering a small current when
necessary.
NOTE: The maintain mode technology utilized in Schumacher chargers allows you to
safely charge and maintain a healthy battery for extended periods of time. however,
problems with the battery, electrical problems in the vehicle, improper connections
or other unanticipated conditions could cause excessive current draws. As such,
occasionally monitoring your battery and the charging process is recommended.
11. MAINTENANCE INSTRUCTIONS
11.1 After use and before performing maintenance, unplug and disconnect the battery
charger.
11.2 Use a dry cloth to wipe all battery corrosion and other dirt or oil from the connectors,
cords, and the charger case.
11.3 Ensure that all of the charger components are in place and in good working condition.
11.4 Servicing does not require opening the unit, as there are no user-serviceable parts.
11.5 All other servicing should be performed by qualified service personnel.
12. STORAGE INSTRUCTIONS
12.1 Store the charger unplugged, in an upright position.
12.2 Store inside, in a cool, dry place.
12.3 If the charger is moved around the garage or transported to another location, take care
to avoid/prevent damage to the cords, connectors and charger. failure to do so could
result in personal injury or property damage.
13. TROUBLESHOOTING
PROBLEM
Charger will not turn on
when properly connected.
Charger makes a loud buzz
or hum.
ChARgINg
ChARgED LED is
flashing.
LED will blink.
LED is lit, the charger has started maintain mode. In this
AC outlet is dead.
Poor electrical connection.
Transformer laminations
vibrate (buzz).
Charger is in abort mode.
is flashing.
battery is 80% charged and
is "ready to use".
POSSIBLE CAUSE
5
• •
LED will blink. To reset after
REASON/SOLUTION
Check for an open fuse or
circuit breaker supplying the
AC outlet.
Check the power cord and
extension cord for a loose
fitting plug.
No problem, this is a normal
condition.
See Section 10 oPERATINg
INSTRUCTIoNS – Aborted
Charge.
See Section 10 oPERATINg
INSTRUCTIoNS – Quick
Charge.