Installation Of Safety Support - Kichler 300370 Manual De Instrucciones

INSTALLATION OF SAFETY SUPPORT

(required for Canadian installation ONLY)
Flat Washer
A safety support cable is provided to help prevent the ceiling fan from faIling, please
Wood Screw
Support Brace
install it as follows.
Spring Washer
Ceiling
Outlet Box
Step 1. Drive a wood screw and washers into the side of the brace that holds the outlet
box. Leave 3mm (1/8") of space between the support brace and the washer. (Fig. 11)
Step 2. Insert the safety cable through the mounting bracket and one of the holes in
Fig. 11
the outlet box into the ceiling. Adjust the length of the safety cable to reach the screw
and washers by pulling the extra cable through the cable clamp until the overall length is
correct, put the end of the cable back through the cable clamp, forming a loop at the end
of the cable. Tighten the cable clamp securely. Now, put the loop in the end of the safety
cable over the wood screw and under the washer. Tighten the wood screw securely.
(Fig. 12)
Safety Cable
Bolt
NOTE: Although the safety support cable is required for Canadian installations only,
Wood Screw
it's a good idea to make the attachment with any installation.
Fig. 12
10 | KICHLER.COM