Gas Connection; Conversion To Other Types Of Gas - Fagor B-G7051 Instrucciones De Instalación, Uso Y Mantenimiento

• When several appliances are installed in series, they should be earthed to each
• An easily accessible omnipolar magneto-thermal circuit breaker of suitable
• An easily accessible differential protection device of suitable capacity should be
• If any faults are observed during the installation, the supplier should be notified
• Before replacing the switchboard cover, fasten the electric supply cable
The manufacturer will not be held liable for any personal or material damage to the
machine resulting from incorrect installation or failure to comply with the manufacturer's
specifications.

4.5 Gas connection

An AUTHORISED TECHNICIAN should always carry out the gas connection of the appliance.

4.6 Conversion to other types of gas

If the appliance is prepared for a different type of gas to the one available in the installation, you
should proceed as follows:
1. Disconnect the gas supply to the appliance if connected (Any change to the conditions of the
gas circuit must be carried out by an AUTHORISED TECHNICIAN).
2. Burner conversión:
a. Remove the control holder panel from the barbecue.
b. Remove the burner injectors and replace with the correct model according to the gas
c. Set the air control to position H (table 3) depending on the gas to be used.
d. Replace the control holder panel.
3. Pilot conversión:
a. Remove the control holder panel from the barbecue.
b. Undo the pilot unit.
c. Remove the pilot injectors and replace with the correct model according to the gas
d. Replace the pilot unit.
e. Replace the control holder panel.
this requirement.
other using the point assigned for this purpose, located at the rear of the appliance.
capacity should be installed next to the appliance, with a minimum gap of 3 mm
between contacts. This switch should be used to disconnect the appliance during
installation, repair, cleaning and maintenance work. It should have locking/labelling
capacities. The manufacturer will not be held liable for damage originated by failure
to observe this requirement.
installed next to the appliance. The manufacturer will not be held liable for damage
originated by failure to observe this requirement.
immediately.
tightly to the stuffing box.
• The general installation must have a main tap and a pressure regulator and it is
also advisable to install a shut-off cock on each individual appliance.
• A pipe of at least Ø 12 x 10 mm should be used for the gas connection, together
with a ¾" nut to connect to the barbecue.
to be used (Table 3).
to be used (table 3).
38