Kohler Purist K-3080 Guía De Instalación Y Del Usuario página 6

Press tab on both sides
while lifting drawer
Model K-3081 shown
4. Secure the Cabinet/Vanity
- Remove the drawer to finish mounting the cabinet/vanity. Pull the drawer out to full extension. Lift drawer while
simultaneously pressing in side tabs to remove.
- Inside the cabinet/vanity, measure down 2 1/2" (6.4cm) from the inside top and 2" (5.1cm) from each side and
mark with a pencil.
- Drill a small hole (smaller than the screw diameter) at marked intersections through the back of cabinet or vanity
and into the wall to accommodate the fasteners (not provided). 3" (7.6cm) long wood screws are the
recommended fasteners. Holes should locate into the brace.
- Secure with the fasteners.
B
1011584-2-
Drawer lifts out
Brace Behind Wall
6
3" (7.6cm) Wood Screw
(recommended)
Kohler Co.