Safety Recommendations - W&H Sterilizer Calibration Device Manual Del Usuario

Safety advice

Safety recommendations

The product shall be used and serviced in accordance with these instructions for use, otherwise the protection provided by the
•
equipment may be impaired. The user is responsible for the correct use and maintenance of the product in accordance with the
instructions listed in this manual.
The product is intended for indoor use only.
•
The product must not be used in presence of explosive or flammable gases, vapours, liquids or solids.
•
If the device comes from a cold place, wait until all external and internal surfaces are free from moisture and condensate before
•
powering it.
Before using the product, check it for integrity and absence of any damage (due to shocks, exposure to high temperature or to liquids,
•
and any other possible cause of damage).
Keep away from direct sunlight and other heat or humidity sources.
•
Do not remove or cover the name plate or any label from the product.
•
Do not pour water or any other liquids over the product.
•
Repairs, checks, maintenance and service must be carried out by the manufacturer only, at his own facilities.
•
Connect only to devices featuring double insulated, limited energy circuit.
•
Always transport in its specific case, supplied by the manufacturer.
•
Disconnect power supply before cleaning: Never use disinfectants or abrasive products.
•
The product is not, and cannot replace, an official validator device. An official validation must be carried out after calibration.
•
All drawings, images and texts contained in this manual are the property of the manufacturer.
All rights reserved. Even partial duplication of drawings, images or text is prohibited.
The information contained in this document is subject to change without prior notice.
ENGLISH
DEUTSCH
FRANÇAIS
ESPAÑOL
5