Publicidad
Step 11
Turn six ANGLED HEAD CAM SCREWS (3) into the RIGHT END (A).
å
Push two LONG WOOD DOWELS (6) into the short edge of the RIGHT END (A).
å
Fasten two RIGHT CABINET RAILS (II) to the RIGHT END (A). Use six BLACK 1/2" FLAT HEAD SCREWS (18) through the
å
2nd, 3rd, and 5th holes as shown.
Separate a LONG EXTENSION SLIDE (FF) from a LONG EXTENSION RAIL (EE) as shown in the upper diagram. Be
å
prepared, the parts are greasy.
Fasten the LONG EXTENSION RAIL (EE) to the RIGHT END (A). Use three 1/2" PAN HEAD SCREWS (20).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other two holes that line up with the holes in the RIGHT END. Turn the
SCREWS into those holes.
NOTE: The LONG EXTENSION SLIDE will be used later for the DRAWERS.
å
Use this hole.
Angled head
(6 used)
421113
Use these holes.
EE
Push the black lever down and pull the SLIDE from the RAIL.
BLACK 1/2" FLAT HEAD SCREW
(6 used for the CABINET RAILS)
3
www.sauder.com
18
5
4
5
4
A
II
3
EE
20
1/2" PAN HEAD SCREW
(3 used for the EXTENSION RAIL)
FF
6
II
3
2
1
2
1
Roller end
Open end
Page 15
Publicidad
