Publicidad
Step 2
Turn six ANGLED HEAD CAM SCREWS (3) into the LEFT UPRIGHT (C).
å
Fasten two RIGHT CABINET RAILS (II) to the LEFT UPRIGHT (C). Use six BLACK 1/2" FLAT HEAD SCREWS (18)
å
through the 2nd, 3rd, and 5th holes as shown.
Separate a LONG EXTENSION SLIDE (FF) from a LONG EXTENSION RAIL (EE) as shown in the upper diagram. Be
å
prepared, the parts are greasy.
Fasten the LONG EXTENSION RAIL (EE) to the LEFT UPRIGHT (C). Use three 1/2" PAN HEAD SCREWS (20).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the upper diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other two holes that line up with the holes in the LEFT UPRIGHT. Turn
the SCREWS into those holes.
NOTE: The LONG EXTENSION SLIDE will be used later for the LARGE DRAWERS.
å
Use this hole.
BLACK 1/2" FLAT HEAD SCREW
(6 used for the CABINET RAILS)
4
5
5
3
(6 used)
Page 6
Use these holes.
EE
Push the black lever down and pull the SLIDE from the RAIL.
18
1
2
3
1
2
II
3
II
4
C
1/2" PAN HEAD SCREW
(3 used for the EXTENSION RAIL)
Roller end
EE
www.sauder.com
FF
20
Open end
Angled head
421113
Publicidad
