Publicidad
Step 12
Turn six ANGLED HEAD CAM SCREWS (3) into the RIGHT UPRIGHT (D).
å
Fasten two LEFT CABINET RAILS (JJ) to the RIGHT UPRIGHT (D). Use six BLACK 1/2" FLAT HEAD SCREWS (18)
å
through the 2nd, 3rd, and 5th holes as shown.
Separate a LONG EXTENSION SLIDE (FF) from a LONG EXTENSION RAIL (EE) as shown in the upper diagram. Be
å
prepared, the parts are greasy.
Fasten the LONG EXTENSION RAIL (EE) to the RIGHT UPRIGHT (D). Use three 1/2" PAN HEAD SCREWS (20).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the upper diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other two holes that line up with the holes in the RIGHT UPRIGHT.
Turn the SCREWS into those holes.
NOTE: The LONG EXTENSION SLIDE will be used later for the DRAWERS.
å
Use this hole.
1/2" PAN HEAD SCREW
(3 used for the EXTENSION RAIL)
Angled head
Page 16
Use these holes.
EE
Push the black lever down and pull the SLIDE from the RAIL.
20
Open end
Roller end
1
1
2
3
JJ
D
EE
www.sauder.com
FF
BLACK 1/2" FLAT HEAD SCREW
(6 used for the CABINET RAILS)
2
3
JJ
4
5
4
5
3
18
(6 used)
421113
Publicidad
