Publicidad
Step 1
Assemble your unit on a carpeted fl oor or on the empty carton to avoid scratching your unit or the fl oor.
å
Turn six ANGLED HEAD CAM SCREWS (3) into the LEFT END (B).
å
Push two LONG WOOD DOWELS (6) into the short edge of the LEFT END (B).
å
Fasten two LEFT CABINET RAILS (JJ) to the LEFT END (B). Use six BLACK 1/2" FLAT HEAD SCREWS (18) through the
å
2nd, 3rd, and 5th holes as shown.
Separate a LONG EXTENSION SLIDE (FF) from a LONG EXTENSION RAIL (EE) as shown in the upper diagram. Be
å
prepared, the parts are greasy.
Fasten the LONG EXTENSION RAIL (EE) to the LEFT END (B). Use three 1/2" PAN HEAD SCREWS (20).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the holes shown in the upper diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other two holes that line up with the holes in the LEFT END. Turn the
SCREWS into those holes.
NOTE: The LONG EXTENSION SLIDE will be used later for the LARGE DRAWERS.
å
Use this hole.
6
3
2
1
Roller end
Open end
421113
Use these holes.
EE
Push the black lever down and pull the SLIDE from the RAIL.
18
BLACK 1/2" FLAT HEAD SCREW
(6 used for the CABINET RAILS)
5
4
5
4
JJ
JJ
3
2
1
www.sauder.com
Look for this icon. It means a
video assembly tip is available at
www.sauder.com/services/tips
1/2" PAN HEAD SCREW
(3 used for the EXTENSION RAIL)
B
EE
FF
20
3
(6 used)
Angled head
Page 5
Publicidad
