Publicidad
Step 3
Flip the LEFT UPRIGHT (C) over.
å
Turn three ANGLED HEAD CAM SCREWS (3) into the LEFT UPRIGHT (C).
å
Push two LONG WOOD DOWELS (6) into the short edge of the LEFT UPRIGHT (C).
å
Separate a SHORT EXTENSION SLIDE (HH) from a SHORT EXTENSION RAIL (GG) as shown in the upper diagram.
å
Be prepared, the parts are greasy.
Fasten the SHORT EXTENSION RAIL (GG) to the LEFT UPRIGHT (C). Use three 1/2" PAN HEAD SCREWS (20).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the upper diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other two holes that line up with the holes in the LEFT UPRIGHT. Turn
the SCREWS into those holes.
NOTE: The SHORT EXTENSION SLIDE will be used later for the KEYBOARD SHELF.
å
Insert a GROMMET (9) into the large hole in the LEFT UPRIGHT (C).
å
Use this hole.
6
Open end
1/2" PAN HEAD SCREW
(3 used for the EXTENSION RAIL)
421113
Use these holes.
GG
Push the black lever down and pull the SLIDE from the RAIL.
9
GG
20
www.sauder.com
HH
3
C
Angled head
Page 7
Publicidad
