Care Instructions - American Standard TOWNSEND 7353.101 Instrucciones De Instalación

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

TEST INSTALLED FITTING

• With HANDLE (1) in OFF position, turn on WATER

SUPPLIES (2) and check all connections for leaks.

• Remove AERATOR (3).

• Operate HANDLE (1) to flush water lines thoroughly.

• Replace AERATOR (3).

CHECK DRAIN CONNECTIONS

• Fill lavatory with water. Check that DRAIN STOPPER (4)

makes a good seal and retains water in SINK.

• Release DRAIN STOPPER (4) down and check all drain

connections and "P" trap for leaks. Tighten if necessary.

SERVICE

CAUTION

• To remove or replace cartridge:

– Turn valve to OFF position.

– Pull out PLUG BUTTON (1) and remove HANDLE SCREW (2).

– Pull off HANDLE (3) and CAP (4).

– Unthread CARTRIDGE NUT (5) and remove.

– Pull out CARTRIDGE (6).

– Inspect CARTRIDGE (6) and O-RINGS (7) for debris and

clean if necessary.

– Clean MANIFOLD (8) and rinse clean.

– Reinstall CARTRIDGE (6) and O-RINGS (7) onto

MANIFOLD (8).

– Reinstall CARTRIDGE NUT (5), CAP (4) and HANDLE

ASSEMBLY (3).

• If spout drips, operate handle several times from OFF to ON

and HOT to COLD position. Do not force - handle turns only 90˚.

ADJUST HOT LIMIT SAFETY STOP

By restricting HANDLE rotation and limiting the amount of

hot water allowed to mix with the cold, the HOT LIMIT SAFETY

STOP (9) reduces risk of accidental scalding. To lower the

maximum hot water temperature of your faucet, all you need to

do is adjust the setting on the HOT LIMIT SAFETY STOP (9).

Note: The HOT LIMIT SAFETY STOP (9) is set at the neutral

setting from the factory. Fig. A.

• To adjust HOT LIMIT SAFETY STOP:

– Remove HANDLE ASSEMBLY (3), CAP (4) and

CARTRIDGE NUT (5).

– Set the CARTRIDGE STEM (10) to the OFF position.

– Lift up the HOT LIMIT SAFETY STOP (9).

– Place the HOT LIMIT SAFETY STOP (9) in the desired GRAY

SHADED AREA (11) to limit the hot water. Fig. B.

– Reinstall CARTRIDGE NUT (5), CAP (4) and HANDLE ASSEMBLY (3).