Phono Mode (Record Player); Bt Out Mode - auna Berklee TT-Classic Manual De Instrucciones

PHONO MODE (RECORD PLAYER)

1. Turn the mode knob to PHONO.
2. Select the desired speed (33/45/78 RPM) and place the record on the
turntable. If you are playing a 45 RPM record, use the 45 RPM adapter.
3. Remove the needle guard from the needle. Release the tone arm from
the tone arm clamp.
4. Operate the tone arm lever to raise the tone arm. Gently move the tone
arm to the desired position over the record. Press the tone arm lever
again to slowly lower the tone arm to the desired position on the record
and start playback.
5. When the record has finished playing, press the tone arm lever again to
raise the tone arm. Put the tone arm back on the armrest. Operate the
tone arm lever to lower the tone arm.
Please note:
• When the Auto Stop switch is ON, the record will automatically stop
when it is finished. When the Auto Stop switch is OFF, the record will not
stop when playback is finished.
• Do not touch the tip of the needle with your fingers.

BT OUT MODE

This function allows music played on the unit to be transmitted to an
external BT speaker or BT headphones via a wireless BT connection.
1. Turn the mode knob to the BT OUT position. The mode indicator turns
blue and flashes.
2. Switch on the external Bluetooth receiving device (BT speaker or BT
headphones) and enter pairing mode.
3. The record player and the external Bluetooth receiver are automatically
connected. This process can take up to approx. 30-45 seconds. To
establish a good connection, do not place the BT receiver more than 1 m
away from the unit.
4. Once the record player is successfully connected to the external BT
speakers, you will hear a short confirmation tone from the speakers and
the function indicator will light up blue.
5. Select the desired speed (33/45/78 RPM) and place the record on
the turntable. The music is played through the external BT speaker/
headphones.
EN
21