Phono: Record Playback; Line In Mode - auna TT-Classic Chrono Manual Del Usuario

EN
18

PHONO: RECORD PLAYBACK

1. Turn the mode selection knob to PH/LINE IN. (Remark: please make
sure that the AUX IN jack is not plugged in with any cable).
2. Connect the power adapter to the unit and mains socket.
3. Turn the power & volume control knob clockwise. The indicator light
will illuminate red.
4. Place a record on the turntable platter and select the desired speed
(33/45/78) according to the record.
When playing a 45-rpm record, use the included 45-rpm adapter located in
the holder besides the platter(one more 45-rpm adaptor can be found in the
accessory bag).
5. Open the tone arm clip to release the tone arm. Push the lift lever
backward to raise the tone arm and gently move the tone arm to the
desired position over the record.
6. The auto stop function applies to most 33-rpm vinyl records. If the auto
stop control switch is turned ON, the record will stop automatically
when finished. If the auto stop control switch is turned OFF, the record
will not stop automatically when finished.

LINE IN MODE

1. Connect your iPod, MP3 player, mobile phones etc. to the AUX IN port
with a 3.5mm to 3.5mm audio cable (not included).
2. Turn the mode selection knob to PH/LINE IN. You can play music from
an auxiliary device through the unit. Turn the VOLUME CONTROL
KNOB to adjust the volume.
Note: The iPod, MP3 player, mobile phones' volume control may also impact
the volume level. So ensure this is also turned up.