BABYTREND HC02XXXA Manual De Instrucciones página 8

ASSEMBLY
TO USE SAFETY BELT
WARNING:
should be used only by children
capable of sitting upright unassisted
and at least 6 months of age.
WARNING:
Prevent serious
injury or death from falls or sliding
out. Always use the restraint system.
The child should be secured in the
high chair at all times by the 5-point
restraining system, either in the
reclining, semi-reclining or upright
position.
10) • The shoulder straps of the 5-point harness have 2
attachment positions. Select the position that places the
shoulder strap level with, or below, the top of the child's
shoulders (Fig. 10a).
• Carefully place the child in the seat and position the safety
harness around the child's waist and over the shoulders.
Place the crotch strap between the child's legs. Insert the
male end of each shoulder / waist belt into the buckle on
the crotch strap. Tighten the harness to be snug around the
child's waist and over the child's shoulders (Fig. 10b).
TO RELEASE SAFETY BELT
11) • Push Button on Center Clasp, the two Harness Buckles
will pop free (Fig. 11).
RECLINE SEAT
12) • Squeeze recline lever on back of the seat and adjust to
the preferred recline or upright position (Fig. 12).
Use caution not to trap arms, hands and fingers when
adjusting recline positions.
11
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
The highchair
Fig. 10a
Fig. 10b
Center Clasp
Fig. 11
Fig. 12
TO ADJUST SEAT HEIGHT
WARNING:
Do not
adjust seat height with child
in seat. Adjust seat height
before placing your child in
the high chair.
WARNING:
Always
check that the height
adjustment bracket is level
and both left and right sides
locked before placing child in
the high chair.
WARNING:
Never
rest the height adjustment
bracket on the locking pins.
13) • Squeeze the Release Handles on both sides
simultaneously of the Height Adjustment
bracket (Fig. 13a) and adjust to the ideal
position (Fig. 13b).
DO NOT adjust with child in the seat.
ATTENTION: Make sure the Height Brackets
lock on the lowest position.
DO NOT rest Height Adjustment Brackets on
the Locking Pins (Fig. 13c).
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
OPERATION
Release Handle
Fig. 13a
Highest Position
Lowest Position
Locking Pin
Fig. 13b
Fig. 13c
12