Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Assemble the Backboard
E
ATTACH THE ELEVATOR TUBE ASSEMBLY
2. While the system is securely resting on the sawhorse, attach both triangle plates (33) to the top
pole section (12) using the bolt (36) and nut (39).
WARNING
TIGHTEN THE BOLTS (36) IN THE LOCK NUTS (39) UNTIL FLUSH (EVEN) WITH THE LOCK NUT'S OUTER EDGE.
NOTE
TEST-FIT THE LARGE BOLTS INTO THE LARGE HOLES OF THE ELEVATOR TUBES, BACKBOARD BRACKETS, AND
TRIANGLE PLATES. CAREFULLY ROCK THEM IN A CIRCULAR MOTION TO REAM OUT ANY EXCESS PAINT FROM
HOLES, IF NECESSARY.
#33
#36
#12
#33
#39
21
Publicidad
Tabla de contenido
