Test-Fit Close Tolerance Bolts; Package Contents; Base Assembly - SPALDING TF Gold 54 Manual Del Propietário

Test-Fit Close Tolerance Bolts

Test-Fit Close Tolerance Bolts
To ensure optimal playability of the backboard system, a close tolerance fit between the elevator components and
hardware is required. Test-fit large bolts into large holes of elevator tubes, backboard brackets, and triangle plates.
Carefully rock them in a circular motion to remove any excess paint from holes, if necessary.
Not all items pictured are included with every model.

Package Contents

Check the contents of each kit and other parts to ensure that all components are present. Keep the kit hardware in
the labeled bag as they will be used in different assembly steps.
See "Parts List" on page 34 for a complete list of replacement part numbers.

BASE ASSEMBLY

#1
#3
#4
1 Base, Plastic, Black (x1)
4 Wheel Bracket, Steel (x2)
11 Middle Pole, Black (x1)
NOTE
#2
#5
2 Ball Return, Plastic, Black (x1)
5 Wheel, 4", Plastic, Black (x2)
12 Top Pole, Black (x1)
#10
#11
#12
#17
3
10 Bottom Pole, Black (x1)
17 Washer, Flat, Plastic, Black (x2)
4
Strut, Steel Tube, Black (x2)