Electrical Connection; Cable Connection - Piron PF4003 Traducción De Las Instrucciones Originales

V.

ELECTRICAL CONNECTION

WARNING: Mains connection must be carried out by a qualified and authorised technician according
to national, international and local laws in the country where it is installed.
Before mains connection, ensure that the frequency (.....V) and voltage (....Hz) meet the requirements
indicated in the in the information tag on the back of the appliance.
WARNING: if the device does not come with a trolley to facilitate transport, it is advisable to connect it first
then place it in position in the work area ensuring the cable is not damaged during placement. This enables
easy and safe connection. Ensure that the cable is uniformly exposed to a room temperature no higher than
50°.
OVENS WITH CABLE AND SINGLE PHASE PLUGS
For appliance with cable and plug (single phase 220-240V) the plug merely needs to go into the appropriate
socket (the socket must be adapted for the supplied plug and must withstand the voltage required by the
appliance indicated on the information plate). The product must be positioned so that the plug is always
accessible.
The appliance comes with certified cable and plug therefore they must not be tampered with or modified.
Only the cable can be substituted: this must be carried out by a qualified authorised technician. The
earth wire must always be yellow green.
APPLIANCE NOT SUPPLIED WITH CABLE WITH THREE PHASE TERMINALS
Articles supplied by us come with terminals such as
in the image. To connect to the mains see the label
in the manual and stuck to the lower part of the back
of the appliance near the Information Plate.
The oven must be connected to the electricity with a
rubber cable such as H07RN-F.
WARNING: the yellow/green voltage wires in the
earth cable must be 3cm longer than the others.
The oven must be connected directly to the mains
and must have an easily accessible switch from the
start ,installed for the device according to the
national, international and local laws in the country
where it is installed. This switch must separate
polarization guaranteeing complete disconnection in
accordance with the overvoltage III category.
Correct earthing is obligatory and the earth wire
must not be operated by the protection switch.

CABLE CONNECTION

Proceed as follows to connect the power supply wire to the terminal board:
•
( A1 ) Loosen the tops of the cable gland and open the bottom part of the back of the appliance by
loosening the screws.
•
( A2 ) Feed the new cable through the cable gland. Connect the cable voltage to the terminal strips
following the connection diagram on the label on the back of the appliance. Only connect what is
indicated inserting the copper bridge and the electricity cable together under the screws, in the
tightening direction, so the cable and the bridge are tightly fixed by tightening the screw. The type of
E n g l i s h | 4