Metabo HPT DS 18DEX Instrucciones De Seguridad Y Manual De Instrucciones página 18

English
14. Using the hook
The hook is used to hang up the power tool to your
waist belt while working.
CAUTION
● When using the hook, hang up the power tool
fi rmly not to drop accidentally.
If the power tool is dropped, it may lead to an
accident.
● When carrying the power tool with hooked to
your waist belt, do not fi t any bit to the tip of
power tool. If the sharp bit such as drill is fi tted
to the power tool when carrying it with hooked to
your waist belt, you will be injured.
● Install securely the hook. Unless the hook is
securely installed, it may cause an injury while
using.
(1) Removing the hook.
Remove the screws fi xing the hook with Philips screw
driver. (Fig. 18)
(2) Replacing the hook and tightening the screws.
Install securely the hook in the groove of power
tool and tighten the screws to fi x the hook fi rmly.
(Fig. 19)
Hook
18
Screw
Hook
Fig. 18
Groove
Screw
Fig. 19
15. Reactive force control
This product features a reactive force control (RFC)
to minimize the danger of twisting the operator's arms
when tool itself suddenly jerks during operation.
When the tool's built-in control detects a reactive
force, it stops the motor's output before the entire tool
jerks to lessen the twisting of the operator's arms.
When this function activates, it will be indicated by the
LED light blinking (0.1-second blinks/off 0.1 seconds).
(Fig. 20)
(See "16. LED light warning signals")
However, as the function may not activate depending
on situations or conditions during operation, so care
should be taken to avoid any sudden overburdening
of the tool bit when operating the tool.
● Possible causes of sudden overburdening
Tool bit biting into material
Impact against nails, metal or other hard objects
Tasks involving prying or any excess application of
pressure, etc.
Also, other causes include any combination of the
aforementioned.
● When the reactive force control (RFC) is triggered
When the RFC is triggered and the motor stops, turn
off the tool's switch and remove the cause of the
overburdening before continuing operation.
Tool bit locks
16. LED light warning signals
This product features functions that are designed to
protect the tool itself as well as the battery. If any of
the safeguard functions activate during operation, the
LED light will blink as described in Table 9. When any
of the safeguard functions are triggered, immediately
remove your fi nger from the switch and follow the
instructions described under corrective action.
Fig. 20