Operational Cautions - Metabo HPT DS 18DEX Instrucciones De Seguridad Y Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Safeguard
LED Light Display
Function
Overburden
On 0.1 second/off
Protection
0.5 second
(rapid blinking)
Blinks for
approximately 3
seconds after the
Reactive
switch has been
Force
released.
Control
On 0.5 second/Off
0.5 second
Temperature
(slow blinking)
Protection
Blinks while
protection is in
eff ect.

OPERATIONAL CAUTIONS

Resting the unit after continuous work
(1) The power tool is equipped with a temperature
protection circuit to protect the motor.
Continuous bolt-tightening work may cause the
temperature of the unit to rise, activating the
temperature protection circuit and automatically
stopping operation.
If this happens, allow the power tool to cool before
resuming use.
(2) After use for continuous tightening wood screw works,
rest the unit for 15 minutes or so when replacing the
battery. The temperature of the motor, switch, etc.,
will rise if the work is started again immediately after
battery replacement, eventually resulting in burnout.
Table 9
Corrective Action
If the operating
with the shift knob
set on "2", adjust
to "1" and continue
operation.
Remove the
cause of the
overburdening.
Remove the
cause of the
overburdening.
When operating
the tool, fi rmly hold
the tool to make
sure it doesn't jerk.
Allow the tool
and battery to
thoroughly cool.
English
19

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Dv 18dex

Tabla de contenido