Power Supply; Basic Settings - IMG STAGELINE TWIST-50LED Manual De Instrucciones

vided on the lower side of the moving head, then
GB
turn them clockwise to the stop. Screw the clamp,
together with the moving head, to the crossbar.
WARNING Install the light effect unit safely and
expertly. If it is installed at a place
where people may walk or sit under
it, additionally secure it (e. g. by a
safety rope: Fasten the safety rope
via the threaded eye bolt provided in
such a way that the maximum falling
distance of the unit will not exceed
20 cm. Screw the eye bolt into the
corresponding threaded jack on the
lower side of the unit).

4.2 Power supply

WARNING To prevent damage to your eyes,
never look directly into the light
source for a long time.
Please note that fast changes in light-
ing, e. g. flashing light, may trigger
epileptic seizures with photosensitive
persons or persons with epilepsy!
Connect the mains cable provided to a mains jack
(15), then connect it to a socket (230 V~ / 50 Hz). The
head (1) and all control motors go to their starting
positions. The display (9) meanwhile shows
to indicate that the moving head is ready for opera-
tion. It is either operated via a DMX light controller
( chapter 6) or automatically runs through the
control program adjusted (
off, disconnect the mains plug from the socket.
For a more convenient operation, it is recom-
mended to connect the moving head to a mains
socket which is switched on and off via a light switch.

4.3 Basic settings

To make the following basic settings via a menu
(see page 59), use the buttons MENU,
ENTER (7). Press the button MENU repeatedly
until the display (9) shows the desired function.
Then press the button ENTER.
Note: If you do not press any button for one minute, the
moving head will stop the setting procedure and return to
the normal operating mode.
Light patterns in two colours
Press the button
Light patterns (gobos) in one colour: The
colour wheel latches at a single colour.
Light patterns in two colours: Positions
between two colours are possible.
To memorize, press the button ENTER.
14
chapter 5). To switch
or to select:
Blackout mode on or off
Press the button
The light beam is always activated. Select
this setting when operating the moving
head without DMX controller.
The light beam is only activated when a
DMX control signal is present at the jack
DMX INPUT (10). Once the DMX controller
has been switched off, the light beam is
deactivated.
To memorize, press the button ENTER.
Pan direction normal or opposite
For operation with two TWIST-50LED moving
heads, the arm of one unit may pan in one direction
while the arm of the second unit pans precisely in
the opposite direction.
Press the button
pan direction normal
pan direction opposite (inverted)
To memorize, press the button ENTER.
Tilt direction normal or opposite
For operation with two TWIST-50LED moving
heads, the head of one unit may tilt in one direction
while the head of the second unit precisely tilts in
the opposite direction.
Press the button
tilt direction normal
tilt direction opposite (inverted)
To memorize, press the button ENTER.
Display on or off
Press the button
The display is always on.
The display is switched off approximately
, and
60 seconds after you press the last button.
It is switched on again when you press the
next button.
To memorize, press the button ENTER.
Display mode
Press the button ENTER to select and to memorize
at the same time:
normal display when the moving head is
upright
display turned by 180° when the moving
head is suspended from the ceiling
To exit the setting mode, keep the button MENU
pressed until the moving head starts the operating
or to select:
or to select:
or to select:
or to select: