Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT OVERVIEW:
LOCK PIN
HANDLE
DMX OUT
DMX IN
POWER IN
POWER OUT
IMPULSE CONTROL SIGNAL INPUT 12V
CONTROL PANEL:
Error Indicator
DMX Signal Indicator
DMX
Menu
MENU
CONNECTORS ON THE REAR PANEL:
DMX
output
DMX
input
DMX IN
DMX OUT
Power
output
Power
input
POWER IN
POWER OUT
Plug in the supplied mains lead into the POWER IN socket of the machine. If you wish to daisy-
chain several machines, plug another power lead into the POWER OUT socket and the other end
into the POWER IN connector of the following machine.
Plug a 3-pin DMX cable into the DMX IN socket and the other end into the DMX OUT connector of
your DMX controller. If you want to connect another machine, connect the DMX OUT connector to
the DMX IN connector of the following machine.
IMPULSE terminals: When an external 12V control signal is connected to these terminals, the ma-
chine will start loading gas and fire automatically once the gas charge has been completed.
This function is used with firing systems to trigger the shooting without the need of a DMX
controller.
INSTALLATION OF THE MACHINE
Install the machine on a solid horizontal ground or truss via four M8 nuts on the base plate.
ERR
RUN
-
+
ENTER
Decrease
Increase
ON
ON/OFF
switch
OFF
POWER
IMPULSE
12V control
signal input
IMPULSE
HOPPER
NOZZLE
POWER
SAFETY RING
Working Indicator
Enter
www.afx-light.com
3
EN
Publicidad
Tabla de contenido
