Tabla de contenido
Publicidad
LDAC
• Use devices powered by Android 8.0 or later to experience LDAC
quality sound.
• LDAC provides higher quality sound, increases power consumption,
and reduces playtime.
• Enable LDAC in a low-interference environment to ensure a stable
Bluetooth connection.
1. Go to settings in the soundcore app. 2. Click on "Sound Mode".
POWERING OFF
1
Return the earbuds to the charging case and close the case.
The earbuds will automatically power off after 30 minutes if they are not
connected. The duration can be set in the soundcore app.
LED LIGHT GUIDE
Steady white
Flashing white
Flashing white in sequence
Light off
1
2
<5%
Pairing
5% - 30%
Connected
30% - 70%
>70%
3. Select "Preferred audio quality" to switch to LDAC codec.
4. You will be notified that the earbuds do not support LDAC when
connected to two devices. Select "Turn on" to continue.
5. It takes about 10 seconds to switch audio codecs. You may be
requested to update the earbuds' firmware if available.
RESET
2
Reset if the earbuds have issues pairing with each other or with other
devices.
Delete the pairing history from your Bluetooth device first. Place the
earbuds in the charging case and leave the case open. Then press and
hold the button on the case for 10 seconds until the LED indicators on
the case flash white 3 times and then flash in sequence.
FIRMWARE UPDATE
2s
You will be informed once the new version of firmware is detected when
you connect the earbuds with the app. Ensure the earbuds are placed in
the charging case and the case remains open until the firmware update
is completed. During the update, ensure the earbuds are being charged
and avoid any usage.
EN 03
3
4
1
1
5
2
10s
×3
2
Publicidad
Tabla de contenido
