Replacing The Oven Light - Furrion FMCM15A-BL Manual Del Usuario

8. Reinstall the vent grille screws.
Replacing the Surface Light
WARNING
Electric Shock Hazard
●
Disconnect electrical power before servicing.
●
Failure to do so can result in death or electric shock.
CAUTION
To avoid risk of personal injury or property damage, wear
gloves when replacing the light bulbs.
1. Unplug the microwave oven or turn off power at the main
circuit breaker.
2. Remove the LED light cover mounting screws at both light
positions under the microwave.
3. Remove the LED light mounting screw.
4. Unplug the LED light from the harness, replace with LED
light. Then reconnect the harness.
5. Re-install LED light and mounting screw. When re-installing
mounting screw be careful not to damage the LED light.
6. Re-install LED light cover and mounting screw.
7. Plug the microwave back into the power supply or turn the
power back on at the main circuit breaker.

Replacing the Oven Light

To access the light cover remove the Charcoal Filter per
instructions of 1-4 in "Replacing the Charcoal Filter" section.
1. Open light cover located behind Microwave Carbon Filter
by carefully pulling up on the front edge.
2. Remove the LED bracket and light assembly. Remove
the LED light from the bracket by removing the mounting
screw and replace only with part LED Board.
3. Re-install LED light to the bracket with mounting screw.
When re-installing mounting screw be careful not to
damage the LED light.
4. Reconnect LED light to the harness and place the LED
light assembly back into the plastic housing.
- 20 -
CCD-0006074 Rev: 09-16-22