Kuppersbusch KI6870.0SR Instrucciones De Uso página 47

EN
instructions for use
as adequate or
stovetop protectors
incorporated into
the device. The use
o f i n a d e q u a t e
p r o t e c t o r s c a n
cause accidents.
It is necessary to
allow the appliance
disconnection after
i n s t a l l a t i o
n . Disconnection
devices must be
incorporated to
i n s t a l l a t i o n ,
according to the
installation regu-
lations.
Installation
Installation with cutlery drawer
If you wish to install furniture or a
the two. Accidental contact with the
hot surface of the device's housing is
thus prevented.
ath the under part of the stovetop.
Electrical connection
Before you connect the stovetop to
together with this manual throughout
the product's service life.
Ensure that the inlet cable does not
come into contact with the induction
is installed in the same unit.
46
Warning:
The electrical connection
must be properly grounded,
following current legislation,
otherwise the induction hob may
malfunction.
Unusually high power surges
can damage the control system (like
with any electrical appliance).
It is advised to refrain from
using the induction hob during the
pyrolytic cleaning function in the
case of pyrolytic ovens, due to the
high temperature that this type of
device attains.
o f f i c i a l t e c h n i -
cal service can handle or repair the
appliance, including replacement of
the power cable.
form the mains, we recommend
waiting for approximately 23
seconds before disconnecting from
the mains. This time is required to
allow for the complete discharge of
the electronic circuitry and thus
preclude the possibility of electric
shock from the cable terminals.
Keep the Guarantee
Certificate or the technical data
sheet together with the instructions
manual throughout the product's
service life. These contain
important technical information.
About induction
Advantages
transmitted directly to the pan.
This has a number of advantages:
-Saves time.
-Saves energy.
-Easy to clean as if the food comes into
burn easily.
-Improved energy control. The energy
is transferred to the pan as soon
as the power controls are pressed.
power supply stops. It is not necessary
Pans
Only ferromagnetic pans are suitable
for use with an induction hob.
There are several types:
use with induction hobs.
We do not recommend the use of
Each cooking zone has a minimum pan
detection time. This depends on the
material and the ferromagnetic diameter
of the base of the pan. Therefore it is
essential to use the cooking zone that
best matches the diameter of the base
of the pan to be used.
If the pan is not detected on the
next smallest zone.
When the Flex Zone is used as a single
this type of zone can be used (see
Fig. 3
Some pans without a complete
ferromagnetic base are sold as
base is heated. Consequently the
heat is not evenly distributed across
the base of the pan. This may mean
that the non-ferromagnetic part of the
base of the pan does not reach the
right cooking temperature.
Fig. 4