Roland VS-890 Manual Del Usuario página 125

4. Apéndices
G Tabla decimal y hexacimal
(Hexadecimal number is shown with H.)
In MIDI documentation, data values and addresses/sizes of system exclusive messages etc.
are expressed as hexadecimal values for each 7 bits.
The following table shows how these correspond to decimal numbers.
+——————+——————++——————+——————++——————+——————++——————+——————+
| dec | hex || dec | hex || dec |
+——————+——————++——————+——————++——————+——————++——————+——————+
| 0 | 00H || 32 | 20H ||
| 1 | 01H || 33 | 21H ||
| 2 | 02H || 34 | 22H ||
| 3 | 03H || 35 | 23H ||
| 4 | 04H || 36 | 24H ||
| 5 | 05H || 37 | 25H ||
| 6 | 06H || 38 | 26H ||
| 7 | 07H || 39 | 27H ||
| 8 | 08H || 40 | 28H ||
| 9 | 09H || 41 | 29H ||
| 10 | 0AH || 42 | 2AH ||
| 11 | 0BH || 43 | 2BH ||
| 12 | 0CH || 44 | 2CH ||
| 13 | 0DH || 45 | 2DH ||
| 14 | 0EH || 46 | 2EH ||
| 15 | 0FH || 47 | 2FH ||
| 16 | 10H || 48 | 30H ||
| 17 | 11H || 49 | 31H ||
| 18 | 12H || 50 | 32H ||
| 19 | 13H || 51 | 33H ||
| 20 | 14H || 52 | 34H ||
| 21 | 15H || 53 | 35H ||
| 22 | 16H || 54 | 36H ||
| 23 | 17H || 55 | 37H ||
| 24 | 18H || 56 | 38H ||
| 25 | 19H || 57 | 39H ||
| 26 | 1AH || 58 | 3AH ||
| 27 | 1BH || 59 | 3BH ||
| 28 | 1CH || 60 | 3CH ||
| 29 | 1DH || 61 | 3DH ||
| 30 | 1EH || 62 | 3EH ||
| 31 | 1FH || 63 | 3FH ||
+——————+——————++——————+——————++——————+——————++——————+——————+
* Decimal values such as MIDI channel, bank select, and program change are listed as one
(1) greater than the values given in the above table.
* A 7-bit byte can express data in the range of 128 steps. For data where greater precision
is required, we must use two or more bytes. For example, two hexadecimal numbers aa
bbH expressing two 7-bit bytes would indicate a value of aa x 128 + bb.
* In the case of values which have a +/- sign, 00H = -64, 40H = +/- 0, and 7FH = +63, so
that the decimal expression would be 64 less than the value given in the above chart. In
the case of two types, 00 00H = -8192, 40 00H = +/-0, and 7F 7FH = +8191.
* Data marked "nibbled" is expressed in hexadecimal in 4-bit units. A value expressed as a
2-byte nibble 0a 0bH has the value of a x 16 + b.
<Ex.1> What is 5AH in decimal system?
5AH = 90 according to the above table.
<Ex.2>What in decimal system is 12034H in hexadecimal of every 7 bit?
12H = 18, 34H = 52 according to the above table. So 18 x 128 + 52 = 2356.
<Ex.3> What in decimal system is 0A 03 09 0D in nibble system?
0AH = 10, 03H = 3, 09H = 9, 0DH = 13 according to the table.
So ((10 x 16 + 3) x 16 + 9) x 16 + 13 = 41885.
<Ex. 4> What in nibble system is 1258 in decimal system?
____
16)1258
16) 78 ... 10
16) 4 ... 14
0 ... 4
0 = 00H, 4 = 04H, 14 = 0EH, 10 = 0AH According to the table.
So it is 00 04 0E 0AH.
GEjemplo de un mensaje exclusivo y cálculo de una
suma de comprobación
On Roland system exclusive message (DT1), checksum is added at the end of transmitted
data (in front of F7) to check the message is received correctly. Value of checksum is defined
by address and data (or size) of the system exclusive message to be transmitted.
How to calculate checksum
(Hexadecimal number is shown with H.)
Checksum is a value which lower 7 bit of the sum of address, size and checksum itself turns
to be 0.
hex || dec | hex |
64 | 40H || 96 | 60H |
65 | 41H || 97 | 61H |
66 | 42H || 98 | 62H |
67 | 43H || 99 | 63H |
68 | 44H || 100 | 64H |
69 | 45H || 101 | 65H |
70 | 46H || 102 | 66H |
71 | 47H || 103 | 67H |
72 | 48H || 104 | 68H |
73 | 49H || 105 | 69H |
74 | 4AH || 106 | 6AH |
75 | 4BH || 107 | 6BH |
76 | 4CH || 108 | 6CH |
77 | 4DH || 109 | 6DH |
78 | 4EH || 110 | 6EH |
79 | 4FH || 111 | 6FH |
80 | 50H || 112 | 70H |
81 | 51H || 113 | 71H |
82 | 52H || 114 | 72H |
83 | 53H || 115 | 73H |
84 | 54H || 116 | 74H |
85 | 55H || 117 | 75H |
86 | 56H || 118 | 76H |
87 | 57H || 119 | 77H |
88 | 58H || 120 | 78H |
89 | 59H || 121 | 79H |
90 | 5AH || 122 | 7AH |
91 | 5BH || 123 | 7BH |
92 | 5CH || 124 | 7CH |
93 | 5DH || 125 | 7DH |
94 | 5EH || 126 | 7EH |
95 | 5FH || 127 | 7FH |
Implementación MIDI
If the address of the system exclusive message to be transmitted is aa bb ccH and data or
size is dd ee ffH,
aa + bb + cc + dd + ee + ff = sum
sum / 128 = quotient and odd
When odd is 0, 0 = checksum
When odd is other than 0, 128 - odd = checksum
IControl del equipo MIDI (MMC) Comando, campo
de información / referencia de la respuesta
GComandos reconocidos
Command Action
01H STOP STOP
02H PLAY PLAY
03H DEFERRED PLAY PLAY
04H FAST FORWARD FF
05H REWIND REW
06H RECORD STROBE REC / PUNCH IN
07H RECORD EXIT PUNCH OUT
0DH MMC RESET RESET
40H WRITE Write to Information Fields
41H MASKED WRITE Set Track Status Information Fields
44H 00H LOCATE I/F LOCATE (Read Locator)
44H 01H LOCATE TARGET LOCATE (Designated Time)
4CH MOVE Move between Information fields
GComandos transmitidos
Command Action
01H STOP STOP
03H DEFERRED PLAY PLAY
06H RECORD STROBE REC / PUNCH IN
07H RECORD EXIT PUNCH OUT
0DH MMC RESET RESET
44H 01H LOCATE TARGET LOCATE
GCampos de información válida / Respuesta
Information Field Interpret
01H SELECTED TIME CODE Current Time
08H GP0 / LOCATE POINT Locator 1
09H GP1 Locator 2
0AH GP2 Locator 3
0BH GP3 Locator 4
0CH GP4 Locator 5
0DH GP5 Locator 6
0EH GP6 Locator 7
0FH GP7 Locator 8
4FH TRACK RECORD READY Track Status
Valid Commands
MOVE(FROM)
MOVE(FROM), MOVE(TO), WRITE
MOVE(FROM), MOVE(TO), WRITE
MOVE(FROM), MOVE(TO), WRITE
MOVE(FROM), MOVE(TO), WRITE
MOVE(FROM), MOVE(TO), WRITE
MOVE(FROM), MOVE(TO), WRITE
MOVE(FROM), MOVE(TO), WRITE
MOVE(FROM), MOVE(TO), WRITE
MASKED WRITE, WRITE
125