Shortcut Keys - SAME DEUTZ-FAHR iMonitor Uso Y Mantenimiento

The user is alerted to incoming phone calls by a popup, as shown in the
fi gure:
to answer the incoming, call press the knob;

to refuse the call, press ESC (2) on the user interface.


SHORTCUT KEYS

In this screen the user can defi ne the associations between the various applications and the shortcut buttons F1 - F2 - F3 - F4 - F5.
The fi rst column lists the applications, while the second column shows the screen
pages.
To set the functions, use the knob to fi rst select the required application in the
left-hand column, then the required corresponding screen page in the right-hand
column.
1. Applications
2. Pages
3. Functions currently assigned to the shortcut keys
SOFTWARE VERSION
This page displays information about the software installed on the on-board com-
puter and also enables the user to update the software.
The screen displays the following functions:
1. RESET: restores original settings
2. SAVE: saves the current iMonitor settings to a USB stick
3. LOAD: uploads iMonitor settings from a USB stick
4. Updates the terminal
IMPORTANT
The software updating procedure must only be performed by authorised personnel with the engine switched off and
the ignition key turned to the fi rst position.
If it is necessary to update the software, proceed as follows:
insert the USB memory stick containing the software update;

turn the knob to select the function "Update terminal";

press the knob;

wait for the confi rmation message;

turn the ignition key to STOP;

turn the ignition key to the fi rst position.

1-6
USE AND MAINTENANCE
Fig. 12
Fig. 13
Fig. 14