Welding Current - gala gar Smart 120 Mini Syner Manual Técnico De Instrucciones

Smart 120 Mini Syner
3.4 PULSED STICK WELDING (PULSED MMA)
3.4.1 INSTALLATION OF PULSED STICK WELDING (PULSED MMA)
The purpose of this type of arc is to obtain greater control over the welding input. The result is a succession
of 2 overlapping intensities in the form of a bead, with each impulse guaranteeing penetration and partial
solidification of the weld.
A low frequency will provide more heat and penetration, highlighting the waters of the bead. On the contrary,
a high frequency will provide less heat and deformation to the joint, marking less the waters.
The installation shall be the same as for the MMA process.
3.4.2 ADJUST AND PARAMETERISATION OF STICK WELDING (MMA).
Gala Gar, S.L. c/ Jaime Ferrán, 19 (Políg. Cogullada) | Tel.: (+34) 976 47 34 10 - 50014 ZARAGOZA |

WELDING CURRENT

Turn the encoder to set the desired output current.
(20 to 120 amps)
HOT START
To adjust the Hot Start percentage, press the encoder
until the icon has a white arrow underneath it.
Turn the encoder to set the desired percentage.
Press the encoder to save the parameter.
ARC FORCE
To adjust the Arc Force percentage, press the encoder
until the icon has a white arrow underneath it.
Turn the encoder to set the desired percentage.
Press the encoder to save the parameter.
VRD (Voltage Reduction Device)
To activate or deactivate the VRD function, press the
encoder until the icon has a white arrow underneath it.
Turn the encoder to set the desired value (ON/OFF).
Press the encoder to save the parameter.
Installation for the PULSE WELDING of COATED ELECTRODE.
+ −
19/49
M
www.galagar.com