Bolt-down instructions... continued
F
F
F
NOTE: • The safe should not be bolted to a wall, this will compromise the fire rating.
Drill holes through the feet only. DO NOT drill through the back or sides.
• Bolting/unbolting the unit is at the consumer's expense and discretion.
• SentrySafe / Master Lock is not responsible for any costs incurred if the unit is
to be replaced.
• When bolting down, ensure the gasket washer is facing down.
• If rubber pads are in place, remove them before drilling.
Not all SentrySafe products come with a bolt-down kit.
Please go to www.sentrysafe.com to learn more about the recommended hardware for
your safe.
Bolting Down Your Safe
Move the safe aside to clear both marked spots for drilling.
5
Drill into the floor:
6
A. For wood: Using the
(64 mm) deep in each marked spot.
B. For masonry: Using the
(64 mm) deep in each marked spot. Install a masonry
anchor in each hole.
Replace the safe in the desired position, with the holes in
7
the safe aligned with those in the floor.
Securing the safe:
8
A. For wood: Pass each lag screw through a washer,
then through the safe and into a hole. Tighten with
the wrench.
B. For masonry: Pass each lag screw through a washer,
then through the safe and into a masonry anchor.
Tighten with the wrench.
12
⁄
" drill bit, drill a hole 2
9
32
⁄
" drill bit, drill a hole 2
3
8
⁄
"
1
2
⁄
"
1
2