Troubleshooting - SentrySafe Master Lock Fire-Safe Manual Del Propietário

Troubleshooting

The Problem:
The door will not
close and lock.
After inputting the
programmable code,
the door does not
open.
Red indicator light
blinks three times
and there are
three beeps.
Red indicator light
blinks five times and
there are five beeps.
Red indicator light
blinks once and there
is one beep.
Red indicator light
is blinking.
Yellow indicator light
is on.
Why it is Happening:
1. Confirm that there is no
obstruction in the door.
2. Bolted down incorrectly.
1. Battery Power may be low.
2. May be the wrong battery
type.
An incorrect code has been
entered.
Keypad communication error.
1. Program button is pressed out
of sequence.
2. 5 seconds has lapsed between
button entries.
An incorrect code has been
entered three times and system
has entered delay mode.
1. Battery power is low.
2. Battery may be the wrong
type.
13
The Solution:
1. Remove all items and accessories
from inside the safe. If this resolves
the issue, re-set the accessories and
organize items to properly fit.
2. See pages 11 for proper bolt-down
instructions.
1. Use override key to open the safe
and replace batteries.
2. Use 9 volt battery to open your safe
and replace the batteries.
Verify code and re-enter. If the pro-
grammable code you are using does
not work then use the factory code. If
successful re-program your program-
mable code.
Please call our Customer Service center.
Start over.
Wait two minutes and start over.
Replace with new CR123 lithium
batteries.