Programming information
NOTE: • The "C" key is a clear key. This can be used at anytime to clear the system and return to
standby mode – unless you are in delay mode (3 consecutive invalid entries).
• The 5 digit factory code cannot be deleted. However, you may add and delete
additional codes.
This safe can store up to five codes at one time. One factory code and 4 additional
programmable codes.
Programming the user code
To ADD a user code:
Press "P" on the keypad.
1
Enter the 5 digit factory code found on the back of your owner's manual.
2
The light will flash green and then you will have five seconds to enter your own
3
personal 5 digit user code.
To DELETE a user code:
Press "P" on the keypad.
1
Enter the 5 digit factory code.
2
Enter 0,0,0,0,0.
3
NOTE: • The electronic lock will NOT indicate that it has deleted the user code – please test the
code to make sure it has been deleted.
Programming the secondary code
To ADD a secondary code:
Press "P" on the keypad two time.
1
Enter the 5 digit user code previously programmed.
2
Programmable Electronic Lock
Three code options:
Factory code:
The safe will ALWAYS unlock using this 5 digit code (found on the
back of the owner's manual). This code cannot be deleted.
User code:
A 5 digit programmable code of your choosing that can be changed
or deleted.
Secondary code:
Up to 3 secondary 5 digit programmable codes can be changed or
deleted. A secondary can only be programmed after a user code
has been activated.
8