SentrySafe Master Lock Fire-Safe Manual Del Propietário página 9

The light will flash green and then you will have five seconds to enter your own
3
personal 5 digit secondary code.
Repeat steps 1-3 in order to add an additional secondary code.
4
To DELETE a secondary code:
Press "P" on the keypad two time.
1
Enter the 5 digit user code.
2
Enter 0,0,0,0,0.
3
Repeat steps 1-3 in order to delete an additional secondary code.
4
NOTE: • The electronic lock will NOT indicate that it has deleted the secondary code – please
test the code to make sure it has been deleted.
• Secondary codes will be deleted in the order they were programmed.
Changing your batteries
Battery auxiliary override
If battery power in the safe is running low and cannot operate the safe, you will need to use the
battery auxiliary override feature to open the safe.
IMPORTANT: This should not be used as a primary means to gain entry into the safe.
Locate the battery pack compartment on the inside of the door
1
and remove the cover.
Insert two CR123 lithium batteries.
2
Replace battery pack cover.
3
NOTE: • Do not use rechargeable batteries or any other type
of non- CR123 lithium battery. Do not mix old and
new batteries.
Open the silicone cap found on the side of the lock.
1
Pull out the wire inside the lock and attach a 9 volt battery.
2
Enter your five digit code.
3
Pull handle outward to open the door.
4
9