Observations; Warranty Conditions - Sagola DM 300 Manual De Instrucciones

Pay adequate attention when handling the unit in order to prevent any damage that might lead
to dangerous situations for the user or personnel standing near the unit, as a consequence of
leaks, breakages, etc.
The equipment has been designed for use at room temperature. The maximum operating tem-
o
perature is 50 C.
The use of solvents and/or detergents that contain halogenated hydro-
carbons (trichloroethane, methyl chloride, etc.), may cause chemical
reactions in the unit as well as in its zinc-coated components (trichloroe-
thane mixed with small amounts of water produces hydrochloric acid).
For this reason, these components may rust and in extreme cases the
chemical reaction caused may be explosive. We recommend you to use
products that do not contain the aforementioned components. Do not
use acids, soda (alkalis or pickling substances, etc.) for cleaning under
any circumstances.
In general, precautions must be taken whenever the unit is handled, in order to prevent any
damage to this.
Connectors must be securely tightened and in good condition. If pneumatic connectors are
fitted, they must comply with the standard ISO 4414:2010.
Safety standards must be understood and applied.
Any non-compliance with the indications set out in this manual may lead to incidents affecting
the physical integrity of the user or other personnel or animals.
Respect and comply with indications relating to the conservation of the environment.
Always keep the safety sheets for the products to apply and the cleaning liquids to hand in case
you need to consult them.

16. Observations

By following the instructions set out in this manual you will ensure good spraying and quality of
finish. Should you have any doubt, please contact the Technical Service of SAGOLA.

17. Warranty Conditions

This device has been manufactured with great precision and has been subjected to a large num-
ber of controls before leaving the factory.
The WARRANTY is valid for 3 years, counted as of the date of purchase, which will be indicated
by the seller in the place provided for this purpose, together with his stamp. Once the unit has
been received, please complete the warranty and send this to the manufacturer for validation
This WARRANTY covers any manufacturing defect, which will be repaired without charge. Howe-
ver, any malfunction resulting from the incorrect use of the unit, such as inadequate connections,
breakage due to dropping, or similar, the normal wear of components and in general any defi-
ciency not attributable to the manufacturer of the device, are expressly excluded. Likewise, the
WARRANTY shall be rendered null and void when it is evident that the unit has been handled by
persons other than our Technical Assistance Service.
This WARRANTY does not support any undertaking made by anyone outside our Technical
Service.
ENGLISH