General Notes - Amana ASXS61A Serie Instrucciones De Instalación

S S - p
yStem tart up

GENERAL NOTES:

Adequate refrigerant charge for the matching indoor unit
and line set is supplied with the outdoor unit. If liquid line set
exceeds factory charge length, refrigerant should be added
based on liquid line. Refer pages 22-26 for calculation
of refrigerant charge based on line set length.
NOTICE
V EPa
iolation of rEgulations may rEsult in finEs or othEr PEnaltiEs
NOTICE
a
ll units should haVE a high VoltagE PowEr suPPly connEctEd
2 .
hours Prior to startuP
rEfrigErant undEr PrEssurE!
• d
o not oVErchargE systEm with rEfrigErant
• d
o not oPEratE unit in a Vacuum or at nEgatiVE PrEssurE
f
ailurE to follow ProPEr ProcEdurEs may causE ProPErty dam
,
agE PErsonal injury or dEath
o
PErating thE comPrEssor with thE suction ValVE closEd will
causE sErious comPrEssor damagE
.
by our warrantiEs
u
sE rEfrigErant cErtifiEd to
may causE comPrEssor damagE
. m
warranty ost PortablE machinEs cannot clEan usEd rEfrigEr
ahri
ant to mEEt standards
S - p
tart up rocedure
Outdoor unit liquid and suction valves are closed to contain
the charge within the unit. The unit is shipped with the valve
stems closed and caps installed. Do not open valves until
the indoor unit and line set is evacuated.
P
rolongEd oPEration at suction PrEssurEs lEss than
5
for morE than sEconds will rEsult in oVErhEating of thE com
PrEssor and may causE PErmanEnt damagE to it
1. Connect the vacuum pump with 250 micron capability
to the service valves.
2. Evacuate the system to 500 microns or less using suction
and liquid service valves. Using both valves is necessary.
3. Close pump valve and hold vacuum for 10 minutes.
Typically pressure will rise during this period.
• If the pressure rises to 500 microns or less and
remains steady the system is considered leak-free;
proceed to start-up.
rocedure
WARNING
.
.
CAUTION
-
such damagE is not coVErEd
CAUTION
ahri . u
standards sEd rEfrigErant
,
and is not coVErEd undEr thE
.
d
etail
CAUTION
20
.
• If pressure rises above 500 microns moisture and/or
noncondensibles may be present or the system may
have a small leak. Return to step 2: If the same result
is encountered check for leaks as previously indicated
and repair as necessary then repeat evacuation.
t t E
hE riPlE
1. Evacuate the system to 4000 microns and hold for 15
minutes. Then, break the vacuum with dry nitrogen.
Bring the system pressure up to 2-3 PSIG and hold
for 20 minutes. Release the nitrogen.
.
2. Evacuate to 1500 microns and hold for 20 minutes. Break
the vacuum with dry nitrogen again. Bring the system
pressure back up to 2-3 PSIG and hold for 20 minutes.
3. Then, evacuate the system until it is below 500 microns
and hold for 60 minutes.
e
lectrical
.
HIGH VOLTAGE!
-
d all
isconnEct
m
ultiPlE PowEr sourcEs may bE PrEsEnt
to do so may causE ProPErty damagE
injury or dEath duE to ElEctric shock
conform with
u
ndErsizEd wirEs could causE Poor EquiPmEnt
,
PErformancE
t
o aVoid thE risk of firE or EquiPmEnt damagE
-
grounding rEquirEd!
a
lways insPEct and usE ProPEr sErVicE tools
or imProPEr tools may causE EquiPmEnt damagE or PErsonal in
. a
jury ll disconnEctEd grounding dEVicEs
bEforE installing or sErVicing
may conduct ElEctrical currEnt
,
thE unit any disconnEction of grounding wirEs
,
cliPs nuts or washErs usEd to comPlEtE thE ground
rEturnEd to thEir original Position and ProPErly fastEnEd
NOTICE
• n
Psig
EVEr install a PhasE
-
EquiPPEd with an inVErtEr
tor will not only dEtErioratE PowEr factor imProVEmEnt Ef
,
fEct but also may causE caPacitor abnormal hEating accidEnt
-
duE to high
• d
o not changE thE sEtting of thE ProtEction dEVicEs
PrEssurE switch
is shortEd and oPEratEd forcibly
sPEcifiEd by
• d
o not connEct thE ground wirE to gas linE
lightning rods
18 18
ASXS6S̲3P679063-2D̲ALL̲220729.pdf
m
Vacuation Ethod is
c
onnectionS
WARNING
.
PowEr bEforE sErVicing
. f
,
PErsonal
. w
iring must
nEc cEc
or and all local codEs
.
EquiPmEnt damagE or firE
WARNING
,
CAUTION
must
. m
ultiPlE comPonEnts of this unit
;
thEsE arE groundEd
-
adVancing caPacitor
,
installing a PhasE
.
frEquEncy waVEs
, ,
thErmal switch or othEr ProtEction dEVicE
,
or Parts othEr than thosE
a ,
mana arE usEd firE or ExPlosion could rEsult
,
or tElEPhonE ground wirEs
(r )
EcommEndEd
ailurE
.
.
usE coPPEr conductors
. l
ack of insPEction
-
bE rEconnEctEd
. i
f sErVicing
, , ,
scrEws straPs
must
bE
.
. a
s this unit is
- -
adVancing caPaci
-
. i
f thE
.
, ,
sEwagE PiPEs
.