R82 Stingray Guia Del Usuario página 31

Safety
Signs, symbols and instructions placed on this product must never be covered or removed and must
remain present and clearly legible throughout the entire lifetime of the product. Immediately replace or
repair illegible or damaged signs, symbols and instructions. Contact your local dealer for instructions.
In case of an adverse event occurred in relation to the device, incidents should be reported to your local
dealer and the national competent authority in a timely manner. The local dealer will forward information
to manufacturer.
Caregiver
• Read the "User Guide" carefully before use
and keep it for future reference. Incorrect
use of this product may cause serious injury
to the user
• This product contains small parts which
could present a choking hazard if removed
from their intended placing
• Information about transportation can
be found in the document "M1460
Transportation in Motor Vehicles" supplied
with the product
• Information regarding frame and seat
combinations including max. load in
combination can be found at: www.etac.com
• Always use the correct lifting techniques and
aids for this purpose
• Never leave the user unattended in this
product. Ensure permanent supervision by
an adult
• Repair/replacements must only be made
using new original R82 spare parts and
fittings and carried out in accordance
with the guidelines and service intervals
prescribed by the supplier
• If there is any doubt as to the continued
safe use of your R82 product or if any
parts should fail, stop using the product
immediately and contact your local dealer
as soon as possible
• Ensure that moving parts does not squeeze
or trap body parts when adjusting them
Environment
• Observe the surface temperature on the
product, before placing an user in it. This
goes especially for users with insensitive
skin as they cannot feel the heat. If the
surface temperature is above 41°C then
allow the product to cool before use
User
• If the user is close to the max. load limit
and/or has a lot of involuntary movements,
e.g. rocking, a larger size with a higher max.
load or a different R82 product should be
considered
• For transportation the product is suitable
for children in the weight range of 22 kg to
specified max user weight for transportation
Product
• Make sure the seat unit is securely mounted
in the frame interface. Check that the
locking system work without obstructions
EN
from e.g. fabric or straps. Remove
obstructions and activate the locking system
• Carry out all positional adjustments on the
product and accessories and ensure that
all knobs, screws and buckles are securely
fastened before use. Keep all tools out of
the reach of children
• Ensure the stability of the product is
maintained before placing the user in it
• We recommend you notify the user before
angling the seat and back
• Ensure the wheels are fully-functional and
secure before use
• Inspect the product and all of its accessories
and replace any worn out parts before use
• This product is tested for resistance to
ignition at level non-ignition in accordance
with EN 1021-1, EN 1021-2 and ISO 7176-
16
• The product might lose its flame resistant
characteristics if using other than original
R82 cushions
• The product is approved for transportation
in vehicles according to ISO 7176-19. More
information can be found in the document
"M1460 Transportation in Motor Vehicles"
supplied with the product.
Even though the product complies with ISO-7176-
19 then:
• Resistance to ignition can change with use,
ageing and/or cleaning
• Precautions should be taken to avoid
sources of ignition, including flames,
cigarettes, etc..
• The environment (such as oxygen, alcohol,
etc.) of the product occupant can increase
the risk of ignitability
31
etac.com