Installation With Vehicle Lap Belt Only - Britax ONE4LIFE CLICKTIGHT Guia Del Usuario

9� Route the lower connector
strap through the
FORWARD-facing belt path
marked by green labels.
10� Firmly press lower
connectors onto their
adjacent lower anchors.
11� Ensure the connector strap
is not twisted. Pull the end
of the lower connector strap
to remove slack.
12� Close the CLICKTIGHT over
the lower connector strap.
13� Ensure both CLICKTIGHT
release buttons are visible.
NOTE: If it is difficult to close,
you may have removed too
much slack.
14� Connect the top tether hook
to the vehicle's top tether
anchor (check the vehicle
owner's manual for location).
15� Pull the top tether strap to
remove slack and secure
excess webbing with the
elastic band attached.
ADJUSTMENT
SLOT
NOTE: Do not install by this method for a child weighing
more than 30 pounds (13.5 kilograms).
28
Table of Contents
CLICK
ADJUSTMENT
SLOT
9 Both red CLICKTIGHT release buttons are visible after installation.
9 All connections are secure and strap is not twisted.
9 Car seat base MUST be flat on vehicle seat and MUST be parallel to
vehicle seat.
9 Recline indicator is still within the correct section for FORWARD-facing,
after securing the child.
9 Child restraint cannot be moved front to back or side to side more than
1 in. (2.5 cm) at the belt path.
9 Excess top tether webbing is contained within your vehicle and secured.
9 The anti-rebound bar MUST be removed.
NOTE: If the child restraint does not meet the above
criteria, repeat the installation steps or use a different
seating location in your vehicle.

Installation with Vehicle Lap Belt Only

1� Extend the top tether strap
by lifting on the top tether
adjuster.
2� Unhook the top tether hook
from the back of the child
restraint and place it up and
over the seatback.
3� Recline child restraint to the
appropriate position. Refer
to page 15 to determine
appropriate recline position.
4� Place child restraint
FORWARD-facing on the
vehicle seat so that the
car seat base is flat on the
vehicle seat and is parallel to
vehicle seat.
5� Ensure that no more than
3 in. (7.5 cm) of the base
hangs over the front edge
of the vehicle seat.
6� Open the CLICKTIGHT.
Squeeze the CLICKTIGHT
release buttons underneath
the front cover flap and lift
to open.
Table of Contents
3 in
29