Britax ONE4LIFE CLICKTIGHT Guia Del Usuario página 22

3� (A) Open the chest clip.
(B) Open the fasteners on
the headrest cover and
remove the harness straps.
4� Flip up the headrest cover.
5� Release the buckle.
6� Position the harness straps
behind the seat pan cover.
NOTE: Located under the
fasteners near the bottom
of the harness straps.
7� Fold the top of the seat pan
cover with the vented side
over. Position the harness
straps behind the seat pan
cover.
8� Fasten the chest clip.
Move the chest clip to the
middle of the back rest.
9� Remove the comfort pads.
a� Tuck each buckle tongue
inside the comfort pads.
Folding them closed.
b� Move both pieces
together towards the
chest clip.
38
Table of Contents
B
A
Seat Pan Cover
Back
Rest
10� Locate the space in-
between the back of the
shell and the back-top part
of the seat pan.
11� Tuck in the buckle tongues
and comfort pads, pushing
them with force down into
the gap until the chest clip
and excess webbing are no
longer visible.
NOTE: Make sure the harness
straps lay flat.
12� Flip up the seat pan cover.
Reattach the fasteners near
the bottom of the harness
straps.
13� Open the CLICKTIGHT.
14� Remove the buckle by
turning the metal bracket
sideways and pushing it
up through the slot in the
CLICKTIGHT and the slot in
the seat cover.
15� Place the buckle
horizontally on top of the
raised section of the seat
shell (in the center) that
guides the harness adjuster
strap.
Table of Contents
Back of
the shell
Seat Pan
Seat
Pan
Cover
39