Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
9 Both red CLICKTIGHT release buttons are visible after installation.
9 All connections are secure and vehicle belt is not twisted.
9 Vehicle belt is locked as directed by your vehicle owner's manual.
9 Car seat base MUST be flat on vehicle seat and MUST be parallel to
vehicle seat.
9 Recline indicator is still within the correct section for REAR-facing after
child is secured.
9 Child restraint cannot be moved front to back or side to side more than
1 in. (2.5 cm) at the belt path.
9 Excess top tether webbing is contained within your vehicle and secured.
NOTE: If the child restraint does not meet the above
criteria, repeat the installation steps or use a different
seating location in your vehicle.
FORWARD-Facing Installation Harness Mode
Britax strongly recommends:
• children should ride REAR-facing until they exceed the
weight or height limits specified.
• the top tether be used at ALL times when installing the
child restraint FORWARD-facing. Using the top tether
will improve the stability of your child restraint and
reduce the risk of injury.
Use FORWARD-facing only:
• with harness straps in closest
position above the child's
shoulder, and
• with children weighing 22 - 65 lb
(10 - 29.5 kg), and
• who are 49 in (124.5 cm) or less in
height, and
• when the top of the ears are
below the top of headrest.
IMPORTANT:
Anti-rebound bar MUST be removed
FORWARD-facing.
Installation with Vehicle Lap-Shoulder Belt (Preferred Method)
1� Extend the top tether strap
by lifting on the top tether
adjuster.
24
Table of Contents
2� Unhook the top tether
hook from the back of the
child restraint and place it
up and over the seatback.
3� Recline child restraint to
the appropriate position.
Refer to page 15 to
determine appropriate
recline position.
4� Place the child restraint
FORWARD-facing on the
vehicle seat so that the
car seat base is flat on the
vehicle seat and is parallel
to vehicle seat.
5� Ensure that no more than
3 in. (7.5 cm) of the base
hangs over the front edge
of the vehicle seat.
6� Open the CLICKTIGHT.
Squeeze the CLICKTIGHT
release buttons
underneath the front cover
flap and lift to open.
7� Route the vehicle lap-
shoulder belt through the
FORWARD-facing belt
path marked by green
labels.
8� Ensure the belt is not
twisted, then buckle the
vehicle seat belt.
9� Remove slack from the lap
part (A), then the shoulder
part (B) of the vehicle seat
belt.
10� Close the CLICKTIGHT
over the vehicle seat belt.
Table of Contents
3 in
B
A
ADJUSTMENT
SLOT
CLICK
25
Publicidad
Tabla de contenido
