Connecting To A Power Source - Pit Boss PBV3D1 Montaje Y Operación

CONNECTING TO A POWER SOURCE

• STANDARD OUTLET
This appliance requires 110-120 volt, 60Hz, 1650w. It must be a 3-prong
grounded plug. Ensure grounded end is not broken off before use.
GFCI OUTLETS
•
This appliance will work on most GFCI outlets, with a recommended
size of 15 or 20 amp service. If your GFCI outlet is highly sensitive to
power surges, it will likely trip during the start-up phase of operation.
During the start-up phase, the element draws 200-700 watts of
electricity which can be too much power for a GFCI outlet to handle.
Each time it trips, it increases in sensitivity. If the GFCI keeps tripping,
replace the outlet or change to a non-GFCI outlet.
IMPORTANT: Disconnect unit from power source when not in use.
7