13. Installing The Cooking Components; Connecting To A Power Source - Pit Boss PRO Serie Manual Del Usuario

13. INSTALLING THE COOKING COMPONENTS

Parts Required:
4 x Cooking Grids (#1)
1 x Heat Deflector Plate (#16)
1 x Water Pan (#17)
Installation:
• Insert the Water Pan into the lowest embossed grid supports of the
interior cabinet. Fill your water pan about ¾ full of water.
IMPORTANT: Keep water in the Water Pan at all times while cooking.
If smoking for an extended period of time, move water pan up
higher to allow water to last longer.
• Next, insert the Heat Deflector Plate into the next set of embossed grid
supports above the Water Pan. Note 13A & 13B for proper placement,
with the "FRONT" facing towards the Cabinet Door.
NOTE: Improper placement of the Heat Deflector Plate will prevent
grease from flowing into the Grease Tray, and may cause grease to
catch fire. Ensure this part is always installed below your Cooking
Grids. The Heat Deflector Plate will catch grease and drippings from
your cooks and allow for easier clean up.
• Lastly, place the four Cooking Grids in the remaining embossed grid
supports in the Main Cabinet.
• The unit is now completely assembled.

14. CONNECTING TO A POWER SOURCE

• STANDARD OUTLET
This appliance requires 110-120 Volt, 60 Hz, 250W . It must be a 3-prong
grounded plug. Ensure grounded end is not broken off before use. The
control uses a 110-120 volt, fast-blow fuse to protect the board from
the ignitor.
• GFCI OUTLETS
This appliance will work on most GFCI outlets, with a recommended
size of 15 amp service. If your GFCI outlet is highly sensitive to power
surges, it will likely trip during the start-up phase of operation. During
the start-up phase, the ignitor draws 200-700 watts of electricity
which can be too much power for a GFCI outlet to handle. Each time it
trips, it increases in sensitivity. If the GFCI keeps tripping, replace the
outlet or change to a non-GFCI outlet.
IMPORTANT: Disconnect unit from power source when not in use.
12
13A
13B
1
1
1
1
16
17
14