Trouble Shooting - VALBERG WF 814 S566C Instrucciones De Uso

C
Useful information
NOTE
• Do not use abrasive or caustic agents to clean plastic parts.
• Clean the detergent dispenser every 3 months to ensure the normal operation
of the appliance.
Cleaning the Drain Pump Filter
WARNING!
• Be careful with hot water!
• Allow the detergent solution to cool down.
• Unplug the machine to avoid electric shock before washing.
• The drain pump filter can filter yarn and small foreign matter from the washing.
• Clean the filter periodically to ensure the normal operation of the washing
machine.
1
Open the lower cover cap
Open the filter by turning it anti-clockwise
Remove any extraneous matter
Close the lower cover cap
CAUTION!
• Make sure the valve cap and emergency drain hose are reinstalled properly, with
the cap plates inserted to align with the hole plates, otherwise water may leak
out.
• Some machines don't have an emergency drain hose, so steps 2 and 3 can be
skipped. Rotate the lower cover cap directly to make water run into the basin.
• When the appliance is in use and depending on the programme selected, there
may be hot water in the pump. Never remove the pump cover during a wash
cycle; always wait until the appliance has finished the cycle and is empty. When
replacing the cover, ensure it is securely re-tightened.
28
2 3
EN
C
Useful information

Trouble Shooting

If there is a problem with the appliance, check if you can resolve it using the tables below.
If the problem persists, please contact customer services.
Description
Appliance does not start
Door can't be opened
Water leakage
Detergent residues in
the detergent dispenser
Indicator or display does
not work
4
Abnormal noise
Error Codes
Description
Possible cause Solution
Door is not closed properly. Close the door properly and restart.
Clothes are stuck. Check the laundry.
Safety protection is activated. Disconnect the power and restart.
Connections are not tight Check and fasten the water inlet pipe.
enough. Check and clean the outlet hose.
Detergent is damp and/or Clean and wipe the detergent
clotted. dispenser dry.
PC board or harness have Switch off the power and check if the
connection problems. mains plug is connected properly.
Check if the fixing bolts have been
Fixing bolts still in place.
removed Make sure the appliance is
Floor is not solid or level.
installed on a solid and level floor.
Possible cause Solution
Door is not closed properly Close the door properly and restart.
Check if the water pressure is high
Water injecting problem during enough.
wash cycle. Straighten the water pipe.
Clean the inlet valve filter.
Overtime water draining Check the drain hose for blockages.
Water overflow Restart the appliance.
Restart the appliance. If the problem
Others persists, please contact customer
services.
29 EN