Operation; To Fill Fuel; To Start The Product - Husqvarna TS 354XD Manual De Usuario

Introduction
WARNING:
the safety chapter before you use the
product.

To fill fuel

WARNING:
flammable. Be careful and refuel
outdoors. Refer to
9 .
CAUTION:
type. Incorrect fuel type causes damage
to the product.
• Use gasoline of the correct type. Refer to .
For more information about the fuel, refer to
the engine manual supplied by the engine
manufacturer.
• Do a check of the fuel level before each use and
refuel if necessary.
• Do not fully fill the fuel tank. Keep a space of a
minimum 1 in.

To start the product

To do before you start the product
WARNING:
product, carefully read and understand
the safety instructions and the operation
instructions.
1. Do a check of the engine oil level. Refer to
a check of the engine oil level on page 29 .
2. Fill the fuel tank with fuel. Refer to
page 13 .
3. Disengage the freewheel mode. Refer to
the product in freewheel mode on page 17 .
4. Sit in the seat in operation position.
5. Engage the parking brake. Refer to
and disengage the parking brake on page 15 .
6. Make sure that the cutting deck is disengaged.
To engage and disengage the cutting
Refer to
deck on page 16 .
To start a warm engine
1. Sit in the seat.
2. Make sure that the cutting deck is disengaged.
To engage and disengage the cutting
Refer to
deck on page 16 .
1940 - 006 - 13.09.2022

Operation

Read and understand
Gasoline is very
Fuel safety on page
Always use correct fuel
Before you operate the
To do
To fill fuel on
To put
To engage
3. Put the cutting deck in transport position. Refer
To set the cutting deck in transport position or
to
mow position on page 14 .
4. Move throttle control to fast position.
5. Pull out the choke control.
Note:
For a warm engine start, it may not be
necessary to use the choke control.
6. Push down on the brake pedal fully and keep it
pushed down.
7. Put the ignition key into the ignition.
8. Turn the ignition key to the "START" position and
release the ignition key when the engine starts.
CAUTION:
starter continuously for more than 15
seconds for each minute.
9. When the engine has started, slowly push
in the choke control until the engine runs
smoothly. When the engine operates smoothly,
the attached equipment can be operated and you
can operate the forward and rearward drive.
Note:
If the engine runs roughly, pull the choke
control out for a few seconds and then continue
to push the choke control in slowly.
Note:
If the engine does not accept the load,
restart the engine and let it warm up for one
minute. Follow the instructions above.
To start a cold engine
1. Sit in the seat.
2. Make sure that the cutting deck is disengaged.
To engage and disengage the cutting
Refer to
deck on page 16 .
3. Put the cutting deck in transport position. Refer
To set the cutting deck in transport position or
to
mow position on page 14 .
4. Move the throttle control to the middle throttle
position.
5. Pull out the choke control.
Do not operate the
13