Cutting Deck - Husqvarna TS 354XD Manual De Usuario

1. Connect one end of the red battery cable to the
POSITIVE (+) battery terminal (A) on the weak
battery.
B
A
2. Connect the other end of the red battery cable
to the POSITIVE (+) battery terminal (B) on the
charged battery.
WARNING:
of the red battery cable touch the
G
1. Park the product on a level surface and engage
the parking brake.
2. Disengage the cutting deck and stop the engine.
3. Put the attachment lift lever in the lowest
position.
4. Remove the the drive belt for the cutting deck
from the electric clutch pulley (A).
5. Remove the lock nut (B), the nut (C), the bushing
(D) and disconnect the front link (E) from the
bracket (F) on the chassis.
6. Remove the clips (G) and the washers and
disconnect the 2 suspension arms (H) from the
chassis.
1940 - 006 - 13.09.2022
C
D
Do not let the ends
I
chassis. This will cause a short
circuit.
3. Connect one end of the black battery cable to
the NEGATIVE (-) battery terminal (C) on the
charged battery.
4. Connect the other end of the black battery cable
to a CHASSIS GROUND (D), away from the fuel
tank and the battery.
To remove the jumper cables
Note:
Remove the jumper cables in the opposite
sequence to how you connect them.
1. Remove the BLACK cable from the chassis.
2. Remove the BLACK cable from the fully charged
battery.
3. Remove the RED cable from the 2 batteries.

Cutting deck

To remove and install the cutting deck
A
H
7. Remove the clips and the washers and
disconnect the rear lift links (I) from the cutting
deck.
WARNING:
links are disconnected from the
cutting deck, the attachment lift lever
is spring loaded. Hold the attachment
lift lever tightly if you change its
position.
8. Remove the cutting deck from the product.
F
D C
E B
When the rear lift
25