Tabla de contenido
Publicidad
LDAC
3
3. Select "Preferred audio quality" to switch to LDAC codec.
4. You will be notified that the headphones do not support LDAC
when connected to two devices. Select "Turn on" to continue.
5. It takes about 10 seconds to switch audio codecs. You may
be requested to update the headphones' firmware if available.
RESET
You might need to reset your headphones if you experience
connectivity or function issues.
Delete the pairing history from your Bluetooth device first.
Press the power and volume up buttons simultaneously for 5
seconds until the LED flashes red three times.
FIRMWARE UPDATE
You will be informed once the new version of firmware is
detected when you connect the headphones with the app.
Ensure the headphones are powered on and connected to a
device until the firmware update is complete. During the update,
avoid any usage and ensure stable access to the internet.
5
4
×3
5s
2
1
AUX
WIRED LISTENING
L
Play audio on an external device by plugging in a 3.5mm
AUX cable. Wired listening will turn off Bluetooth mode
automatically.
LED LIGHT GUIDE
L
Steady red
Steady blue
Flashing white
Flashing blue
Light off
SPECS
Specifications are subject to change without notice.
Input
Rated output power
Battery capacity
Charging time
Playtime (with ANC off)
Playtime (with ANC on)
Driver size
Frequency response
Impedance
Bluetooth version
Bluetooth range
EN 3
R
R
×3
ON
Pairing
3s
Connected
5 V
0.7 A
2.2 mW
750 mAh
2 hours
Up to 65 hours
Up to 50 hours
40 mm
20 Hz - 40 kHz
5.3
15 m / 49 ft
Publicidad
Tabla de contenido
